CLOCKTIMER
English5 Press CLOCK/TIMER again to store the
MINI HIFI SYSTEMTimer Setting
STANDBY NEWS/TAsetting.
ONY The system can switch on to CD,
a The clock starts.
TUNER, or TAPE 2 mode automatically
POWER SAVERDSY To exit without storing the setting, pressat a preset time. It can serve as an
? on the system.alarm to wake you up.
IR SENSOR
CD 1Y2Y3BANDTAPE 1Y2CDR/DVDY Before setting the timer, make sure the
Notes:
C1 CDY 2 Y 3BANDTUNERTAPEAUXCDR
sclock is set correctly.
VECBASS/TREBSEARCHYTUNINGSTOPYCLEAR PLAY PAUSEPREVPRESETSIDE sNEXTVOLUMELE� During clock setting, if no button is
LOTRY The timer will always be switched on
CONpressed within 90 seconds, the system
UND
LSOCLOCK/Donce it is set.
IGITAPROGTIMERDIMA. REV(HSD)DUBRECORDwill exit clock setting modeY The volume of the timer will
automatically.
increase from the minimum level
BASSTREBLE� When a power interruption occurs, the
until the volume level before the set
wOOxclock setting is erased.
PLUSTECHNOLOGYLEVELis switched to standby mode.
� To set the time with RDS clock, see
"Receiving RDS Radio Station" under
1 Press and hold CLOCK/TIMER for more
TUNER section.
View ClockClock Settingthan 2 seconds to select timer mode.
You can view the clock (if it is set) if theThe clock can be set in either 12- or 24-a OAM 12:00� or O00:00" or the
last timer setting starts flashing
system is in Standby mode or when anyhour mode, e.g. "AM 12:00" or
depending on whether you have
sound source is selected (CD, TUNER, etc.)."00:00". Before setting the clock, you
selected 12- or 24-hour mode.
The clock will be displayed for about 7must be in the View Clock mode.
a The TIMER starts flashing.
seconds.
1 Press CLOCK/TIMER to select clocka The selected source is lit while other
Y Press CLOCK/TIMER briefly (or CLOCKmode.available sources are flashing.
on the remote control).2 Press PROG (on the system only) to2 Press CD, TUNER or TAPE to select the
a "PM 10:38 or 22:38" (theselect 12- and 24- hour mode.desired source.
current time) will be displayeda If 12-hour mode is selected,Y Before selecting CD or TAPE, make sure
depending on whether you have"AM 12:00" starts flashing.a CD or tape is loaded in the CD tray or
selected 12- or 24-hour mode.a If 24-hour mode is selected, "00:00"tape deck 2.
a "--:::::--" will be displayed if thestarts flashing.3 PressE ? or ? on the system to set
clock is not set.3 Set the hour withE ? or ? on thethe hour for the timer to start.
system.4 PressE ? or ? on the system to set
Note:
4 Set the minute withE ? or ? on thethe minute for the timer to start.
� When the system goes into low power
system.
standby mode, the clock setting will not
be displayed.
22
pg 01-26/C80/22-Eng223/6/00, 2:24 PM3139 116 19681 |
ACEC
PHILIPS
