6ENGLISH
General description
ASteam tank
BFilling opening with screw cap
CSteam control
Position 1: minimum steam output
Position 5: maximum steam output (types
GC6044/GC6046/GC6048 only)
D'Steam tank heating up' (U) pilot light.The pilot light goes out when
the appliance is ready for steam ironing.
E'Steam tank on/off' (d) switch with integrated pilot light
F'Iron on/off' (d) switch with integrated pilot light
GManometer to verify steam pressure.When the needle is in the
green area, there is sufficient steam pressure (type GC6048 only).
HMains cord
ISupply hose
JIron storage hook with integrated hose storage clip
K'Iron heating up' pilot light
LJet-of-steam button (types GC6046/GC6048 only)
MSteam activator button
NTemperature dial
OSoleplate
PRemovable iron stand
QButton groove with jet-of-steam holes
RAnti-calc funnel (type GC6048 only)
SCord storage facility
Important
For optimal safety, read these instructions carefully and look at the
illustrations before you start using the appliance.
- Do not put perfume, vinegar, descaling agents or other chemicals in
the steam tank.
- Never use the appliance if it is damaged in any way. Regularly check if
the mains cord and the supply hose are still undamaged and safe.
- If the mains cord of this appliance is damaged, it must always be
replaced by Philips or a service centre authorised by Philips, as
special tools and/or parts are required.
- Only use the screw cap of the steam tank that has been supplied
with the appliance, as this cap also functions as a safety valve.
- Check if the voltage indicated on the bottom of the steam tank
corresponds to the mains voltage in your home before you connect
the appliance.
- Only connect the appliance to an earthed wall socket.
- Never immerse the iron or the steam tank in water.
- Never leave the iron unattended when it is connected to the mains.
- When you have finished ironing and even when you leave the iron
for a short while, unplug the iron and put it on the iron stand.
- Always place the steam tank on a stable, level and horizontal surface.
Do not put the steam tank on the soft part of the ironing board.
- Always place the iron on the iron stand. Do not put the hot iron on
the supply hose or the mains cord. |
ACEC
PHILIPS
