2.Avoid using the unit . . .2.Cleaning The Camcorder
... in places subject to excessive humidity or dust.1 Wipe gently the exterior with a soft cloth. Put cloth in
... in places subject to soot or steam such as near a
diluted mild soap and wring it well to wipe off heavy
cooking stove.
dirt, then wipe again with a dry cloth.
... in places subject to excessive shock or vibration.
2Blow the lens with a blower brush, then wipe it gently
... near a television set.
with lens cleaning paper.
... near appliances generating strong magnetic or electric
3Turn the eyepiece counterclockwise and pull it out.
fields (speakers, broadcasting antennas, etc.).
... in places subject to extremely high (over 40!C or 104!F)4Remove dust from the viewfinder using a blower
extremely low (under 0!C or 32!F) temperatures.brush.
5Re-attach the eyepiece and turn it clockwise.
3.DO NOT leave the unit . . .
... in places of over 50!C (122!F).YAvoid using strong cleaning agents such as benzine or
... in places where humidity is extremely low (below 35%)alcohol.
or extremely high (above 80%).YCleaning should be done only after the battery pack has
... in direct sunlight.been removed or other power units have been discon-
... in a closed car in summer.nected.
... near a heater.YMold may form if the lens is left dirty.
... in dusty places such as a beach.YWhen using a cleaner or chemically treated cloth, refer
to the cautions that came with it.
4.To protect the unit, DO NOT . . .
YWhen removing the eyepiece, be sure to hold the
... allow it to become wet.
viewfinder securely.
... drop the unit or strike it against hard objects.
... subject it to shock or excessive vibration during
transportation.
... keep the lens directed at extremely bright objects forThis device complies with Part 15 of FCC Rules.
long periods.Operation is subject to the following two conditions:
... direct the eyepiece of the viewfinder at the sun.(1) This device may not cause harmful interference,
... carry it by holding the viewfinder. Be sure to hold theand (2) this device must accept any interference
main unit with both hands or use the grip. received, including interference that may cause
... swing it excessively when using the shoulder strap.undesired operation.
Change or modifications not approved by the party
responsible for compliance could void the userOs
About moisture condensation . . .authority to operate the equipment. This equipment
YYou may have observed that pouring a cold liquidhas been tested and found to comply with the limits for
into a glass will cause drops of water to form on thea Class B digital device, pursuant to Part 15 of the
glassO outer surface. This same phenomenon occursFCC Rules. These limits are designed to provide
on the head drum of a camcorder when it is movedreasonable protection against harmful interference in a
from a cool place to a warm place, after heating aresidential installation. This equipment generates,
cold room, under extremely humid conditions or in auses, and can radiate radio frequency energy and, if
place directly subjected to the cool air from an airnot installed and used in accordance with the
conditioner.instructions, may cause harmful interference to radio
YMoisture on the head drum can cause severecommunications. However, there is no guarantee that
damage to the video tape, and can lead to internalinterference will not occur in a particular installation. If
damage to the camcorder itself.this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
Serious malfunctioningencouraged to try to correct the interference by one or
more of the following measures:
If malfunctioning occurs, stop using the unitReorient or relocate the receiving antenna.
immediately and consult your local JVC dealer.Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
For Your Maintenancedifferent from that to which the receiver is connected.
1.After UseConsult the dealer or an experienced radio/TV
technician for help.
1Set the Power Switch to OOFF� to turn off the
camcorder.
2Slide EJECT to open the cassette holder, then
remove the cassette.This Class B digital apparatus complies with Canadian
ICES-003.
3Close and lock the cassette holder by pressing the
Close button.
Cet appareil numŽrique de la classe B est conforme ?
4Slide BATTERY RELEASE to remove the batteryla norme NMB-003 du Canada.
pack.
5Attach the provided lens cap to the camcorderOs lens.
27 |
ACEC
JVC
