Master Page: Left
GR-DVP9-8PAL.book Page 52 Friday, February 7, 2003 12:35 PM
52 ENDUBBING (cont.)
1Make sure all units are turned off.
Dubbing From A Video Unit
2Connect this camcorder to a video unit equipped
with a DV output connector using a DV cable as
Equipped With A DV OUT
shown in the illustration.
Connector (Digital Dubbing) 3Set this camcorder?s VIDEO/MEMORY Switch to
?VIDEO?.
(GR-DVP9 only)
4Set this camcorder?s Power Switch to ?P?
while pressing down the Lock Button located on
It is also possible to copy recorded scenes from
the switch.
another video unit equipped with a DV connector
onto the camcorder. Since a digital signal is sent, 5Set ?REC MODE? to ?SP? or ?LP?. (pg.31,34)
there is little if any image or sound deterioration.6Turn on the video unit?s power.
7Insert the source cassette in the video unit.
8Insert the recording cassette in this camcorder.
9Press START/STOP on the remote control to
engage the Record-Pause mode.
I The ?DV. IN ? indication appears on the screen.
10Press START/STOP on the remote control to
start recording.
I The indication rotates.
11Press START/STOP on the remote control
Connectoragain to engage the Record-Pause mode.
Cover*To DV IN/OUTI The indication stops rotating.
12Repeat steps10-11 for additional editing.
Stop the video unit and camcorder.
NOTES:
I It is recommended to use the AC Power Adapter/
Core filterDV cable (optional)
Charger as the power supply instead of the
battery pack. ( pg. 11)
I If no image is displayed on the LCD monitor, set
?S/AV INPUT? to ?OFF?. ( pg. 31, 40)
To DV OUT
I If the remote control is used when both the player
and recorder are JVC video units, both units will
perform the same operation. To prevent this from
happening, press the buttons on both units.
I If a blank portion or disturbed image is played
back on the player during dubbing, the dubbing
may stop so that an unusual image is not dubbed.
I Even though the DV cable is connected correctly,
sometimes the image may not appear in step 9. If
this occurs, turn off the power and make
connections again.
Video unit equipped with DV
connectorI Digital Dubbing is performed in the sound mode
recorded on the original tape, regardless of the
current ?SOUND MODE? setting. ( pg. 34)
* When connecting the cable, open the cover.I When using a DV cable, be sure to use the
optional JVC VC-VDV204U DV cable. |
ACEC
JVC
