GROOVE 1200
Specifications
Input Impedance200K Ohm
Output Power450 Watts8 Ohms @ 5% THD
750 Watts4 Ohms @ 5% THD
1200 Watts2 Ohms @ 5% THD
Actual response is tailored to speakers for accurate acousticalFrequency Response20HZ-20kHz
response using a bass guitar as input.
Hum & Noise-60dbResidual Noise, all level controls 0% (minimum)
27dbPreamp outputSystem Gain
15dbPreamp output, Active
25dbTuner outputAll measurements taken with 1 KHz
27dbDirect output
32dbPower amp gaininput signal, Tone controls flat, Gain and
Volume Maximum. Measured at effects
send output jacks on rear unless noted.
Amplifier TypeClass BDescrete device Class B amplifier
FootswitchAny non-momentary two-button foot switch can be used.
Use any standard tip-ring-sleeve cable
USA/Canada120VAC/60Hz, 1500W nominal
Europe230VAC/50Hz, 1500W nominal
Power RequirementsUK230VAC/50Hz, 1500W nominal
Australia240VAC/50Hz, 1500W nominal
Japan100VAC/50-60Hz, 1500W nominal
mm/kg89 (Height) x 483 (Width) x 390 (Depth), 14 kg
Dimensions
Inches/Pounds3.5 (Height) x 19 (Width) x 15.5 (Depth), 31 lbs
Rack Mounting Instructions
The GROOVE 1200 was designed to mount into a standard 2-space rack. When mounting, use 4
screws to secure the amplifier to the rack. When using only one amplifier, use the bottom 2 spaces in the rack.
However, if more than one amplifier is used, leave one space open between the amplifiers to ensure proper
ventilation (shown below).
9 |