PROGRAMME CHARTGB GSI 4741/GSI 4743
Important:
If a fault occurs or you wish to change the current programme, press the
?START? button for about 5 seconds until the Start indicator lamp switches
off ! Refer to the ?Troubleshooting guide? in these user instructions to
remedy any problems.
Sometimes even when the regeneration salt container is full, the corre-
sponding indicator lamp may illuminate during the first wash cycle.
Switch off the dishwasher once the ?Start? indicator lamp has switched off.
If you switch off the dishwasher during a wash cycle, when switched on
again the dishwasher resumes the cycle from where it was interrupted.
On/Off buttonRinse aid level indicator Eco-Dry
Add rinse aid.Dry cycle without using fans.
Start
Start button indicator lamp:
Switches ?on? when the dishwasher is operaSatlt leing.vel indicator
Flashes when a fault occurs.Add regeneration salt.
Switches off at the end of the programme.
Programme progress indicator
Pre-rinse
Washing
Drying
Programme end
Detergent dispenser:Consumption ***
Final rinse
+) with pre-rinse
temperature:Normal load
ProgrammeLoad -) without pre-rinse
symbolCrockery and cutlery** small large
Water EnergyTime
compart-compart-
(Liter)(kWh)(Min.)
mentment
Crockery to be washed later.--5.- 00.029
Pre-rinse
Normally soiled crockery, with dried-on food. 65 °C- 12.5+ 1.3073
Bio-Eco 50 °C *
Normally or heavily soiled crockery with dried-on food. 65 °C17+.01.+3585
Biological 50 °C * 1)
Normally or heavily soiled crockery. 65 °C+17.0 +1.5085
Normal 65 °C
*) Recommended programme for use with ?new generation? enzyme-based detergent.
**)For pre-rins e.
***)Values for normal conditions. Values may vary in relation to usage, e.g.: different loads, water temperatures, water hardness and power supply voltage.
1) Consult the programme on the energy data plate.
5019 100 90019 |
ACEC
BAUKNECHT
