90404-gb.fm5 Page 2 Thursday, September 22, 2005 5:50 PM
How to use the dishwasherUpper and lower rack
1. After loading the dishwasher, close6. Turn the the programme selector knob The rack must be level on both Lower rack
door properly and open the water counter clockwise to the initial position to sides.
supply tap.switch off the dishwasher (only after thCrockery holders:e A
Down: cups and long-stemmed
2. The dishwasher switches on Start indicator lamp has switched All off).
automatically as soon as the the indicator lamps switch off.glasses.
programme selector knob is turned. 7. Open the door (warning: beware of hUp: plaot tes.A
One of the programme indicator steam). Unload the lower rack before
lamps will switch on.the upper one. Close the water tap.
3. Turn the selector knob to select the Upper rack
desired programme. The corresponding
indicator lamp lights up.If required , C
select options (if supplied).
4. Press the Start button to start the
selected wash programme. The Start
?Vario Organizer? multi-purpose
indicator lamp will liOnce set, ght up. Plate holders:
the programmed data cannot be support:(A) May be lowered to increase
To be used, for example, for
altered by turning the programme long-handled uten(arrange sils available space.
selector knob.
knives with the blade facing
Note: once the Start button has been downwards), cups and glasses.A
pressed, the dishwasher memorises the May be used in three different
last programme selected. This positions (see also ?Dishwasher
information remains in the memory even loading instructions? on Page 4).
during interruption of the power supply.1. Upon the left-hand side of the rack.
To change the selected 2. Upside-down, towards the centre of
programme, press the Start button the rack.
for about 5 seconds, until the Start 3. Upside-down, towards the left side.
indicator lamp switches off.
Select a new programme and press Cutlery basket:
The cutlery basket (C) can be
the Start button.
Note: if the dishwasher is switched off removed to increase available space.
Some models are provided with a
during a wash programme, when grid (D) that can be fitted onto the
switched on again it will resume the wash
cutlery basket.
cycle from where it was interrupted.Rack height adjustment:
Only open the dishwasher door if (The dishwasher is delivered with the upper B
strictly necessary during a wash rack incycle the top po sition).Glass holder:D
and exercise maximum caution. The rack height can also be changed
Danger of scalding from steam.when loaded.
5. To indicate the end of the prog?rammeTo lo, wer: pull ou twot the side
the Start indicator lamp switches off handles and gently lower the rack.
and the End indicator lamp (if fitted)To raise: pull up two side hanthe dles C
lights up (for about 30 min).until the rack clicks into place.
Please read the user instructions carefully. |
ACEC
BAUKNECHT
