How to useReplacing the tube lamps and/or starters
- Check the distance betweenIn the course of time (in normal family use after some years)
15
your body and the solariumthe efficiency of the tube lamps will gradually decrease.
(min. 20 cm or 8"). If this happens, you may increase the tanning session time or
If necessary adjust thehave the tube lamps replaced.
height and/or position of the50M
0IN
solarium.1Y You can have the tube lamps and/or the starters replaced
5
- Set the timer to the session160by authorized service personnel: they have the required skill
0
time (fig. 15). 52and the original replacement parts and tools to do the job.
55
(Please refer to the table in52They also have the facilities to dispose of the used tube
003
these instructions and to530454lamps.
your own notes.)
- Do not forget to put on theY If you prefer to replace the lamps yourself, proceed as
eye goggles provided.follows:
- As soon as the session time- First remove the mains plug from the wall socket.
has elapsed the lamps will automatically be switched off.
- If you wish to treat the other side of your body as well, you
1819
can set the timer again. (It is not necessary for the solarium
to cool down first.)
Lying
- Place the solarium beside a bed or couch.
- As the stand is on wheels
you can draw the solarium
towards you while lying.16
Ensure that the lamps are
positioned straight above
you (fig. 8).
- You can move the stand
under the bed (fig. 16).- Loosen the screws and remove the two end caps (fig. 18).
- After use, you can push the- Pull out the protective shield completely (fig. 19).
solarium away from you toAfter this, the lamps and starters are accessible.
make getting up easier.- Rotate the lamps slightly to the left or to the right.
When unlocked remove them from the lamp holders .
Sitting- Remove the starters by turning slightly to the left and
- Place a (deck) chair and thewithdrawing .
solarium together (fig. 9).(Half the amount of starters are at each end of the
- Bring the solarium in optimum position by turning the uppersolarium.)
casing.- To place new lamps and starters proceed in reverse order
and direction.
Standing- Slide the protective shield back into the profile.
- Turn the upper casing to bring it into a vertical position. Do not forget to fix the end caps by means of the screws.
If necessary adjust the height.
- Stand in front of the solarium (fig. 10) - at least 20 cm (8�)
away. The tube lamps of solariums contain substances which
may pollute the environment. When discarding old tube
lamps, please ensure that they are separated from the
Storagefnormal household refuse and that they are disposed of
at an officially assigned place.
The solarium takes up very
little space when stored in a17
vertical position (fig. 17).
For U.K. only:
Fitting a different plug
This appliance is fitted with a BS 1363 13 Amp. plug.
Should you need to replace the plug, connect the wires as
follows:
Brown wire to the Live (L)terminal of the new plug.
Blue wire to the Neutral (N)terminal of the new plug.
Cleaning
Always fit the same value of fuse as that originally supplied
Y Always unplug the solarium and let it cool down before
with your appliance.
cleaning.
Only use BS 1362 approved fuses.
Y You can clean the outside of the solarium with a damp
cloth. Make sure that no water runs into the appliance.As a guide only: Appliances under 700 W can have a 3 Amp.
Y Do not use abrasives or scourers.fuse (red) and all others should have a 13 Amp. fuse (brown).
Y Never use liquids such as alcohol, methylated spirits,
petrol or acetone to clean the protective plate as thisWhen disposing of an old plug (particularly the moulded type
may cause irreparable damage.which has been cut from the mains cord) always remove the
fuse as the plug could be dangerous if ever inserted in a live
socket.
8 |
ACEC
PHILIPS
