English
Important
YRead these instructions carefully in conjunction with the illustrations before using the
appliance for the first time. Keep these instructions for future reference.
YUnless specific reference is made, these instructions apply to all kettles in the HD 4614-17
range.
YThis kettle has a safety cut-out which protects it against overheating due to operation with
insufficient water. If the kettle ever runs dry, unplug the kettle and allow 10 minutes to cool
down and refill with cold water. Then you can switch the appliance on again.
YPlace the kettle on a cool and firm, level surface.
YNever immerse the kettle or the base unit in water.
YIf the kettle is tipped too far backwards, water may be spilled through the back cover.
Though the kettle will still be electrically safe, extra care must be taken if it contains hot or
boiling water.
YWARNING: If the kettle is overfilled there is a risk that boiling water may be ejected from the
spout.
YPrevent children from pulling the mains cord. Do not let the cord hang over the edge of the
work surface.
YPour away the very first water boiled. The kettle is then ready for use.
YThe kettle must only be used with the base unit supplied.
YIf the supply cord becomes damaged, it must only be replaced by an authorised Philips
service representative as special tools and/or parts are required.
General description (fig. 1)Do not fill the kettle with less than 0.5 litre (up to
?MIN? indication) to prevent the kettle from running
A Water level indicators(types HD 4616/17)dry while operating.
B Maximum / minimum water levelDo notfill the kettle with more than 1.7 litre(up
C Lidto ?MAX? indication) to prevent water being
D On/Off knobejected from the spout while boiling.
E Pilot light
F Base unitSwitching on
G �Filterline� scale filter(type HD 4617)- Place the kettle on the base unit (F).
- Switch the kettle on (fig. 4).
The pilot light (E) will come on.
Cord storage
Switching off
For safety and convenience, the free length of the- The kettle will switch off automatically once the
mains cord can be reduced by pushing the cordwater boils (fig. 5a)
inside the base unit (see fig. 2).- You can switch the kettle off manually at any
Only the minimum necessary length between thetime (fig. 5b).
base unit and the wall socket should be used.Some time after switching off, a click may be
heard. This is of no importance.
How to use the kettleSwitching on again ?
- You can switch the kettle on again after letting it
Fillingcool down for at least half a minute.
- The kettle must not be filled when placed on the
base unit. Take the kettle from the base.
- Fill the kettle through the spout (fig. 3a), or ...
- ... through the lid aperture (fig. 3b). Do not
forget to replace the lid after filling.
4 |
ACEC
PHILIPS
