ENGLISH
Important..4 Put a paper filter (type 1x4 or no.4) in the filter holder (fig. 8).
� Do not use the appliance if the plug, the cord or the appliance itself isDo not forget to fold the sealed edges of the filter in order to prevent tearing and
damaged.folding. Some versions come with a permanent filter. In this case you do not need to
use a paper filter.
Thermos jug:
� Do not disassemble the thermos jug.5 Then fill the filter holder with coffee (filter-fine grind) until the indicator of the
� To prevent water from entering the thermos jug, never immerse the jug inActive Balance System has reached the 'OK' position (fig. 9) and switch the
water or any other liquid (fig. 17).appliance on.
� When the jug is filled with coffee, put it in upright position to prevent leakage
(fig. 18).6 Close the lid (fig. 10).
� During brewing, the lower part of the appliance and the bottom of theSwitching the appliance on or off..
thermos jug will become hot.1 Switch the appliance on by pressing the on/off button (fig. 3).
� Tip: preheating the jug with hot water will help to keep the coffee hot after
brewing. Please note that the coffee stays hot longer if you prepare a full jug2 Switch the appliance off after use (fig. 4).
than if you prepare a smaller amount-Types HD7624, HD7626: If you have not switched the appliance off, the
appliance will automatically switch itself off after two hours (auto switch-off).
If the coffee maker has a longer brewing time or switches off before the -Types HD7634, HD7636: The appliance will switch itself off automatically (auto
water tank is empty, you should descale the appliance (see 'Descaling)'.
switch-off) after brewing coffee.
Before first use..3 Remove the paper filter and throw it away (fig. 11-12).
1 Check if the voltage indicated on the appliance corresponds to the mainsIf you have used a permanent filter, you can simply empty it, rinse it and use it again.
voltage in your home before you connect the appliance.Let the appliance cool down for at least 3 minutes before you start brewing coffee
2 Put the appliance on a cool, flat and stable surface.again.
Do not put the appliance on a hot surfaceCleaning..
3 Remove the red transportation clip (a) before you start using the appliance1 Unplug the appliance.
Keep the appliance out of the reach of children and make sure that they are2 Clean the appliance with a moist cloth.
unable Never immerse the appliance in water.
to pull at the cord.
3 Clean the glass jug and the filter holder in hot water with some washing-up
Flushing the appliance..liquid or in the dishwasher.
The thermos jug cannot be cleaned in the dishwasher.
1 Put the plug in an earthed wall socket.
2 You can store excess cord at the back of the appliance (fig. 1).Thermos jug (fig. 13-14):
Prevent the cord from coming into contact with hot surfaces.
3 Fill the water tank with water and put the jug in place (fig. 2).Clean the inside of the thermos jug with a soft brush, hot water and some washing-
up liquid. The thermos jug is not dishwasher-proof.
Thermos jug:After cleaning, rinse the thermos jug with fresh hot water.
When you operate the appliance without ground coffee in the filter, do not fill the Tip: To remove stubborn brown deposits, fill the jug with hot water and add a
water tank beyond the 9-cup mark, otherwise the jug will overflow.spoonful of soda. Leave the soda to do its work for some time.
4 Switch the appliance on by pressing the on/off button (fig. 3).Then empty the jug and remove the deposits with a soft brush.
The pilot light goes on.
Let the appliance run until the water tank is completely empty.Opening, closing or removing the lid of the thermos jug:
5 Switch the appliance off after use (fig. 4).Open the lid to pouring position by turning it anti-clockwise half a turn (fig. 15).
Clean the removable parts as described in the section 'Cleaning'.Close the lid by turning it clockwise. If properly closed, the insulated jug will keep the
Brewing coffee..coffee hot and tasty for a long time (fig. 16).
Remove the lid by turning it anti-clockwise until it comes off.
Active Balance System
The Active Balance System helps you determine the right balance between groundDescaling..
coffee and water.Regular descaling will prolong the life of your appliance and will guarantee optimal
Before using the Active Balance System, please note the following:brewing results.
Strength selectorIn case of normal use (two full jugs of coffee every day), descale your coffee maker:
Types HD7622, HD7624, HD7626, HD7634, HD7636.- once every 2 months if you are using hard water (over 18 DH);
- once every 4 months if you are using soft water (up to 18 DH).
1 Set the strength of your coffee by means of the strength selector knob (b).
If you prefer mild coffee, turn the knob to the left. If you prefer strong coffee, turnTurn to your local water board for information about the water hardness in your
the knob to the right (fig. 5).area.
Make sure the filter holder is in place when selecting the strength of your coffee.1 Fill the water tank with white vinegar. Do not put a paper filter or coffee in
Reset functionthe filter holder.
2 Let the appliance complete two cycles.
2 Put the system in balance by means of the 'OK' knob (c).See 'Brewing coffee'.
The indicator of the Active Balance System (d) can be put in 'OK' position by turning
the 'OK' knob to the left or to the right (fig. 6).3 Let the appliance complete two more cycles with clean water to rinse away all
When putting the system in balance, make sure that:vinegar residues.
-the filter holder is in place;4 Clean the separate parts.
-the appliance does not contain any water and/or ground coffee.
3 First fill the water tank with water. The indicator of the Active Balance System
goes up (fig 7).
-The level indications apply to cups with a content of 120 ml.
-The level indications on the jug apply to an amount of water that is 10% more
than the total amount of coffee after brewing. This extra 10% is needed to
compensate for evaporation.
4222 001 95264
2/11 |