30115111GB.fm Page 3 Friday, November 19, 2004 6:16 PM
HOT / COLD FILL INSTRUCTION
Connect hot and cold water supply
(Fig. 1):
1. Fix the water inlet hose with the red stripe
at the red valve of the washing machine and
at the hot water tap.
2. Fix the water inlet hose with the blue stripe
at the white valve of the washing machine
and at the cold water tap.
To get the optimum performance you should
use both the hot and cold water supplies. It is
not recommended to convert to cold fill only.
Make sure:
a) The connections are tight, but do not over
tighten by using a tool.
b) Do not invert their position
(for example: cold fill into hot inlet valve
and viceversa).
c) And see instruction for use ?Connect the
water supply hose?.Fig. 1
Do not allow children to operate, crawl on, near or inside your washer.
Note that during wash cycles, the surface temperature of the
porthole door may increase.
Close supervision of children is necessary when the appliance is
used near children.
Whirlpool is a registered trademark of Whirlpool USA
5019 301 15111
Black process 45.0° 100.0 LPI |
ACEC
