ALIGNMENT INSTRUCTIONS
2) FOCUS ADJUSTMENT
? Turn in a local station and adjust the Focus Control knob (located on FBT) for best picture
details at high light condition.
3) RF AGC DELAY ADJUSTMENT (S5)
? Receive a good local channel.
? Enter the service mode and select service adjustment S5.
? You can see the OSD as shown in below.
IF CONTROL
AUTO RFAGC START
VIDEOL 7
RFAGCD 10
FM.LEV 20
AGC POINT 3.75
A/D VALUE : 8DH
MOVE ADJUST RECALL : SET
? Select RFAGCD item, press the volume up or down button until noise or beat in picture disappears.
? Press the DISPLAY button to memorize the data.
4) GEOMETRIC ADJUSTMENTS (S6)
? Enter the service mode and select service adjustment S7.
? Whenever you select the ?S7? using the volume up or down button, the screen is changing like this.
NORMAL BLACK WHITE100 WHITE60 CROSS
? Using the volume up or down button, select internal cross pattern.
? Select service adjustment S6
? You can see the OSD as shown in below.
GEOMETRY
H. PHASE 20
V. POSI 29
V. SIZE 70
NO SD POWER OFF YES
V SC 3
V LIN 23
MOVE ADJUST RECALL : SET
4-1. Horizontal Position Adjustment
? Select H.PHASE item, adjust H.PHASE data value to obtain proper horizontal centering of the
internal cross pattern at the left and right of the screen.
4-2. Vertical Position Adjustment
? Select V.POSI item, adjust V.POSI data value to center the raster properly on thescreen.
8 |
ACEC
