MessageExplanation and Action
Image quality notThis message appears after the printer finds an error in the ink system. One or
assured more of the ink systems have passed their specified life, one or more of the
printhead cleaners are full of ink, or one or more of the printheads has failed an
electrical test, or an alignment or nozzle check.
Press O to continue. You may continue printing, but you may not get your
usual image print quality.
Imaging inksAfter you have finished installing a new ink cartridge, you are asked to confirm
YESthat you have changed the type of ink cartridges from UV Pigmented to Imaging.
installed NO Press = to confirm that you have changed the ink cartridges from UV Pigmented
to Imaging.
Press O to indicate that you have not changed the ink cartridges from UV
Pigmented to Imaging. You will then be given the opportunity of replacing the
incorrect ink cartridges by the correct ones.
Incorrect ink systemAfter you used the Replace Ink System procedure, which was cancelled by a
time?out or aborted; the printer has detected that one or more of the ink systems
are still faulty or have not been fully replaced, as indicated by the flashing
squares. This message also appears if the printer believes that a component is
incorrect; you must then confirm that the ink system is indeed correct, or rectify
the error.
Press O to continue, to replace the ink systems. Printing will be disabled. You
should replace the faulty ink systems immediately.
If you don't correct the error now, you will see the status message aInk
system erroro
InitializingIn the ink system replacement process, you have swapped an Imaging ink system
new ink systemfor a UV Pigmented ink system, or vice versa. The printer will reinitialize and
prepare to print with the new ink system. (This message only applies to firmware
revision levels A.02.08 or higher.)
Wait until the new ink system has been initialized.
Ink cartridgeThe printer has detected that one or more ink cartridges have been removed or
removedcannot be detected, as indicated by the flashing squares.
Press O to check the failing ink cartridge. Printing has been disabled. You should
reseat the ink cartridge immediately. If this does not solve the problem, you
will have to replace the entire ink system (printhead, printhead cleaner,
and ink cartridge) using the Replace Ink System key.
If you don't correct the error now, you will see the status message aInk
system erroro.
User MessagesHP DesignJet CP Series Printers3-5 |
ACEC
