42PMA300EZ (PW1A)
2
ItemVideo Color Temperature Adjustment (B/W)Adj. pointIC
Adjustment PreparationsAdjustment ProceduresRemarks
(1) Set the output of signal (1)Perform the following adjustment with Color temperature should
generator to white raster.the remote control.be adjusted under the
(Ratio : 100%)condition in which the
screen is the brightest, thus
the initial value of
adjustment is it?s maximum
value.
(2) Component signal (480i)(2)Set the CRT color analyzer (CA100) Only reducing the brightness
Video level : 0.714Vp-pat the center of the panel.controls the adjustment,
SYNC : 0.286Vp-pSet Color Temperature of PICTURE thus weaken the brighter
Set-up level : 0VMENU to[B/W].color to adjust.
(3) Set Picture MENU to(3)Ensure that adjustment No. 9, 10, 11
[RESET] are all set as 224.
(4) Set into Factory adjustment (4)After receiving Video signal, Color temperature is at
mode.step down the two (or one) among Cool mode while the
adjustment No. 9, 10, 11 and adjust following No. is selected.
the value as shown below.
At least one of the data should be 224.Adjustment No. 00, 01, 02.
< Specification >
Video color temperature (B/W)
x=0.3350.005
y=0.3430.005
(Color Temp:5400K0MPCD)
24 |
ACEC
