AV-21W33
AV-21W33B
REMOVING THE CRT
* Replacement of the CRT should be performed by 2 or more persons.CRT CHANGE TABLE
After removing the rear cover, chassis etc.,
Y
1. Putting the CRT change table on soft cloth, the CRT change table
should also be covered with such soft cloth (shown in Fig. 2).
APPROX.
2. While keeping the surface of CRT down, mount the TV set on the
35cm
CRT change table balanced will as shown in Fig. 3.
3. Remove 4 screws marked by arrows with a box type screwdriver as
CLOTH
shown in Fig. 3.
YSince the cabinet will drop when screws have been removed, be sure
to support the cabinet with hands.
4. After 4 screws have been removed, put the cabinet slowly on cloth
(At this time, be carefully so as not to damage the front surface of theFig. 2
cabinet) shown in Fig. 4.
The CRT should be assembled according to the opposite sequence
Y
of its dismounting steps.CRT
* The CRT change table should preferably be smaller that the CRT sur-
face, and its height be about 35cm.
CRT
CHANGE
TABLE
BOX
TYPE
SCREW
DRIVER
Fig. 3
CRT
COATING OF SILICON GREASE FOR ELECTRICAL IN-
SULATION ON THE CRT ANODE CAP SECTION.
Subsequent to replacement of the CRT and HV transformer or repair
Y
of the anode cap, etc. by dismounting them, be sure to coat silicon
CRT
grease for electrical insulation as shown in Fig. 5.CABINET
CHANGE TABLE
1. Wipe around the anode button with clean and dry cloth. (Fig. 5)
2. Coat silicon grease on the section around the anode button. At this
time, take care so that any silicon greases does not sticks to the
anode button. (Fig. 6)Fig. 4
Silicon grease product No. KS - 650N
Approx.
CRTAnode buttonSilicon grease 20mm (Do not
should be coated
coat grease on
by 5mm or more
this sectionfrom the outside
diameter of anode
cap.
Silicon greaseAnode buttonCoating position
coating(No sticking ofof silicon grease
silicon grease)
Anode cap
Fig. 5Fig. 6
8No. 52018 |