SECTION 4
ADJUSTMENT
4.1 PREPARATION4.1.3 TOOLS REQUIRED FOR ADJUSTMENT
4.1.1 PrecautionTorque DriverBitTweezers
YTU94088YTU94088-003P-895
Camera system and deck system of this model are specially
adjusted by using PC.
However, if parts such as the following are replaced, an
adjustment is required. The adjustment must be performed in a
Service Center equipped with the concerned facilities.
? OP BLOCK ASSEMBLY
? EEP ROM (IC1005 of MAIN board)Chip IC Replacement JigCleaning ClothGuide Driver (Hexagonal)
PTS40844-2KSMM-01D-770-1.27
In the event of malfunction with electrical circuits, first find a
defective portion with the aid of proper test instruments as shown
in the following electrical adjustment procedure, and then
commence necessary repair/ replacement/adjustment.
? In observing chip TP, use IC clips, etc. to avoid any stress.
Prior to replacement of chip parts (especially IC), remove theINF Adjustment LensINF Adjustment Lens HolderCamera Stand
solder completely to prevent peeling of the pattern.YTU92001BYTU94087YTU93079
? Use a patch cord if necessary. As for a patch cord, see the
BOARD INTERCONNECTIONS.
? Since connectors are fragile, carefully handle them in
disconnecting and connecting the FPC.
4.1.2 REQUIRED TEST EQUIPMENTLight box AssemblyGray Scale ChartColor Bar Chart
YTU93096AYTU94133AYTU94133C
? Personal computer (for Windows)
? Color TV monitor
? Oscilloscope (dual-trace type, observable 100MHz or higher
frequency). The one observable 300 MHz or higher frequency
is recommended.
? Digital voltmeter
? DC power supply or AC adapterAlignment TapePC CableCommunication Cable
MC-1QAM0099-002YTU93107A
? Frequency counter (with threshold level adjuster)
Service Support SystemJig Connector CableExtension Connector
YTU94057-81YTU93106CYTU94145D-40
? Torque driver
Be sure to use to fastening the mechanism and exterior parts
because those parts must strictly be controlled for tightening
torque.
? Bit
This bit is slightly longer than those set in conventional torque
drivers.
? Tweezers
To be used for removing and installing parts and wires.
? Chip IC replacement jig
To be used for adjustment of the camera system.
? Cleaning cloth
Recommended the Cleaning cloth to wipe down the video
heads, mechanism (tape transport system), optical lens sur-
face.
(No.YF042)1-17 |