2.3 DISASSEMBLY/ASSEMBLY OF MECHANISM AS-2.3.2 Explanation of mechanism mode
The mechanism mode of this model is classified into fiveSEMBLY
2.3.1 General statementmodes as shown in Table 2-3-1. Each mechanism mode
can be distinguished from others by the relative position
of O �, OQ�, OQ� O � marks on the sub cam gear to the in-The mechanism should generally be disassembled/assem-
ner or outer protrusion on the main deck.bled in the C.IN mode (ASSEMBLY mode). (Refer to Fig.
2-3-1,2.)
Refer to Fig. 2-3-3 to 2-3-8 below.However, when the mechanism is removed from the main
body, it is set in the STOP mode. Therefore, after the
mechanism is removed from the main body, supply 3 V DC<SUB CAM GEAR>
to the electrode on the top of the loading motor to enter
the mechanism mode into the C,IN mode compulsory.
<Mechanism assembly/Cassette housing assembly>
DC3VTOP VIEWBOTTOM VIEW
Fig. 2-3-3
<C IN mode>
LOADING MOTOR
Fig. 2-3-4
<SHORT FWD mode>
Fig. 2-3-5
<STOP mode>
Fig. 2-3-1
<Back side of the mechanism assembly>
Fig. 2-3-6
C IN mode
<REV mode>
Fig. 2-3-7
<PLAY mode>
Back side of deck
Fig. 2-3-2Fig. 2-3-8
2-3
ACEC
