POWER REQUIREMENTS OF HEADPHONESPOWER REQUIREMENTS OF HEADPHONES
Use two exclusive rechargeable Ni-Cd batteries to power the headphones.
2. Charging rechargeable Ni-Cd batteries
When you purchase this unit, be sure to charge the provided rechargeable Ni-Cd
batteries according to the following procedures before use.
1. Insert the rechargeable Ni-Cd batteries
FFO
NO4
E
CHARG
1
To charging input terminal
To AC outlet
3
2
To CHG. (chargingTo DC IN 12V jack
output terminal)
1Remove the battery compartment cover2Insert the two rechargeable Ni-Cd
on the right side of headphones.batteries with the polarities correctly1Set the ON/OFF (power) switch on the headphones to OFF.
positioned.The batteries cannot be charged when the switch is set to ON.
2Connect the transmitter and the headphones with the provided cord for charging.
3Connect the AC adaptor to the transmitter.
Cautions about the batteries4Plug the AC adaptor into an AC outlet. The charger starts charging the batteries
If the batteries are used incorrectly, they may leak, heat or explode, and may causeautomatically and the transmitters indicator lights in red.
fire, injury or soiling. Make note of the following:
1. Be sure to use the provided exclusive Ni-Cd batteries. Do not use any other rechargeable
Ni-Cd battery or dry cell battery.Charging time
2. Insert batteries with the (+) and () polarities correctly positioned, following the indications
on the equipment.Quick chargingNormal charging
(2 ~ 4 hours)(Approx. 15 hours)
3. Do not use a new battery with an old one, and do not use batteries holding differentQuick charging
amounts of charge together.endsCharging startsFull charging
4. Do not throw batteries in a fire or heat them.
5. Do not short-circuit the positive (+) and negative () terminals. Also, do not carry or storeThe transmitter's indicatorThe transmitter's indicatorAfter full charging is complete,
lights in light red.changes to dark red.the transmitter's indicator
them with small metallic objects such as necklaces or coins.
continues to light in dark red.
6. Do not deform, take apart, modify or directly solder the batteries.
7. Do not remove or damage the covering tube.Battery running time
8. If you notice phenomena that has never happened before, such as leakage, color change or
deformity, stop using the batteries.
After charging is complete, you can use them continuously for the following amounts
9. If any liquid from the batteries gets into your eyes, it may cause blindness. If battery liquid
does get into your eyes, do not rub them, but instead immediately wash them thoroughlyof time:
with clean water, then consult a doctor at once. Also, should any liquid from theQuick charging (2 ~ 4 hours) : 4 ~ 9 hours
rechargeable batteries get onto your skin or clothes, it may burn your skin. In this case,Full charging (19 hours): 13 hours
wash with clean water immediately.
10. Do not immerse or wet the batteries in water.Tips for better use
11. Do not use or leave the batteries in an area where the temperature becomes significantlyI Be sure to charge the batteries within the temperature range of 10° C ~ 35° CHA-RF100S(J)
higher, such as in direct sunlight, inside a car on a hot day or near heat-generating(50 °F ~ 95 °F ).
equipment.
I Charging batteries that are not completely exhausted will cause efficiency to
12. Do not subject the batteries to strong shocks or throw them.
decline. Be sure to charge them after they have been completely exhausted.
13. Be sure to read the cautions on the batteries.
1213
9 |
ACEC
