: Deflection Data Adjustment (Line SVC-1)
NOTE: To enter SVC mode, press "OK" buttons on both TV set
and the Remote control at the same time.
1. Preparation for Deflection Adjustment
1) At SVC mode, press the Yellow colored button.
If the Remote Controller doesn't have the Yellow button, you
should use a Service Remote Control (105-201G) and press
SVC button.
And then, deflection data adjustment OSD (SVC1 mode) will
be displayed.
2) Press Channel UP/DOWN button for desirous functiona
Adjustment.
3) Press Volume UP/DOWN button to adjust the data.
b
2. Deflection Adjustment Procedure<Figure>
VL (Vertical Linearity)
Adjust so that the boundary line between upper and lower3. Deflection Initial Setup Data
half is in accord with geometric horizontal center of the CPT.
PAL 50HzNTSC 60Hz
VA (Vertical Amplitude)Item
NormalWideZoomNormalWideZoom
Adjust so that the circle of a digital circle pattern may be
located within the effective screen of the CPT.VL333028282927
VA313330373333
SC (Vertical OS� Correction)
Adjust so that all distance between each horizontal lines areSC181818181818
to be the same.
VS294140404143
VS (Vertical Shift)HS272929353535
Adjust so that the horizontal center line of a digital circle
pattern is in accord with geometric horizontal center of theEW504655494757
CPT.
EP424848484847
HS (Horizontal Shift)EC262626263039
Adjust so that the vertical center line of a digital circle
pattern is in accord with geometric vertical center of theET282929353029
CPT.VZ3104529043
EW (Horizontal Width)
Adjust to that a digital circle pattern looks like exact circle.
EP (East-west Parabolar)
Adjust so that middle portion of the outermost left and right: White Balance Adjustment.(LINESVC-0)
vertical line looks like parallel with vertical lines of the CPT.
NOTE :This adjustment should be performed after screen voltage
EC (East-west Coner)adjustment.
Adjust so that the vertical line at every 4 corners of the
screen looks like parallel with the vertical lines of the CPT.1) Tune the TV set to receive an 100% white pattern.
2) Press OK(Y) buttons on TV set and remote controller at the
ET (East-west Trapezium)same time to get into SVC mode.
Adjust to make the length of top horizontal line same with it3) Press PSM(RED) button on remote controller. (Standard
of the bottom horizontal line.picture)
4)Press Channel UP/DOWN button for desirous function
VZ (Zoom Mode, Vertical Height)adjustment.
Select the zoom mode with ARC button and adjust the data5) Adjust VOL+ or VOL- button for GG:31.
until the lines a and b of figure are 5~10mm from the top6) Adjust VOL+ or VOL-button in each status of "Rg--"/"Bg--" for
and bottom of CPT and 3~5mm from each sides of CPT.X=293!8, Y=295!8 with color analyzer.
7) Press OK(Y)button to memorize the adjustment data.
- 2 - |
ACEC
