Disassembly E1070
Removing and Replacing the Camera Assemblies
1.Remove the battery cover, battery, SIM, antenna, rear housing, transceiver
board assembly, keypad assembly, flip assembly, flip cover and flip display
assembly PC board as described in the procedures.
The flexible printed cable (FPC) (flex) is easily damaged. Exercise extreme care when
Ghandling.
2.Use the disassembly tool to unseat the VGA camera assembly connector
3.Use the disassembly tool to unseat the VGA camera assembly flex connector
from the display module assembly (see Figure 17).
Disassembly tool
VGA Camera assembly
flex connector
040962o
Figure 17. Removing the Camera Assembly Flex Connector
4.Carefully disconnect the flex connector from the ZIF socket.
5.Lift the VGA camera assembly away from the display assembly PC board.
6.To replace, align the VGA camera assembly connector to its socket on the
display assembly PC board.
7.Gently press the connector onto its socket until properly seated.
8.Replace the flip display assembly PC board, flip cover, flip assembly, keypad
assembly, transceiver board assembly, rear housing, antenna, SIM, battery,
and battery cover as described in the procedures.
34 November 10, 2005 6809497A14-O |
ACEC
