5-9-4. Warm White (2800K)WB Adjustment2) White balance data measurement is preloaded
1) Set the Color Conversion filters (LB40:VFK1341,automatically.
LBA4 : VFK1695) on the from of lens with CC Filter
holder (VFK1345) and the two Step Up Rings5-10. AWT Sensor Adjustment
(VFK1659, VFK1660).5-10-1. AWT Sensor Offset Adjustment
2) White balance adjustment is performed automaticall1) Aim the unit at White Chart under the Halogen lampy.
3) Aim the unit at Color Chip Chart (YWV2100RB98).condition without the CC Filter.
4) Adjust R/G Gain, R/G Phase, B/G Gain and B/G2) Adjustment is performed automatically.
Phase manually so that the Red and Yellow vector
position becomes same as the standard vector figure5-10-2. AWT Sensor Normalize
as follows.1) Aim the unit at White Chart under the Halogen lamp
condition.
2) Cover the CC Filter (LB120:VFK1347) on the front of
the AWT Sensor.
5-9-5. Indoor WB Data Measurement
1) Aim the unit at White Chart under the Halogen lamp3) Adjustment is performed automatically.
condition (3100K, 1400Lux) with CC Filters (LB80 :
VFK1342, LBA8 : VFK1696).6. VIDEO ADJUSTMENT
2) White balance data measurement is preloaded6-1. Sensitivity Adjustment
automatically.1) Set the Camera/VCR switcher to ?Camera? position.
2) Insert the Tape End/Beg. Sensor Cassette (VFK1217)
5-9-6. Outdoor WB Data Measurementinto the Unit.
1) Aim the unit at White Chart under the Halogen lamp3) Press Enter key to perform adjustment automatically.
condition with CC Filters (LB120 : VFK1347, LBB4 :
VFK1697).6-2. Luminance Level Adjustment
2) White balance data measurement is preloaded1) Connect the Oscilloscope to the Video Output with 75
automatically.ohm terminate.
2) Adjust the Y level to become 714?10mV as shown
5-9-7. Cool WB Data Measurementfigure.
1) Aim the unit at White Chart under the Halogen lampNote: Press the F2 Key to see figure.
condition with CC Filters (LB120 : VFK1347, LBA8 :
VFK1696).6-3. Color Level Adjustment
2) White balance data measurement is preloaded1) Connect the Oscilloscope to the Video Output with 75
automatically.ohm terminate.
2) Adjust the Burst level to become 286?20mV as shown
5-9-8. Warm WB Data Measurementin figure.
1) Aim the unit at White Chart under the Halogen lampNote: Press the F2 Key to see figure.
condition with CC Filters (LB40 : VFK1341, LBA4 :
VFK1695).
EAD-9 |
ACEC
