DP-C354/C323/C264/C263/C213
DP-C322/C262
Fax Information Codes
CodeModePhaseDescription of ProblemCause
406RCVBXMT-Password mismatched. RCV-XMT, RCV password does not match.
(Password Password mismatched. Last 4 digits of TSI does not match with
Comm.)Selective RCV incomplete.the last 4 digits of Auto Dial telephone
number.
407XMTDTransmitter received no response Receiver is defective. (No paper, paper
after it transmitted post message, jamming, etc.)
such as EOP, MPS, EOM, etc...or Receiver ceased receiving because of
received DCN.excessive error. (Line quality is poor)
FCB PCB (Modem) is defective.
408XMTDTransmitter received RTN after it Receiver receives data with error. (Line
transmitted EOP, MPS, or EOM.quality is poor)
Receiver is defective. (Modem, etc.)
FCB PCB is defective.
409XMTDTransmitter receives PIN after it Receiver receives data with error due to
transmitted a post message, such poor line quality, and receiving operator
as EOP, MPS, EOM, etc.requests voice contact.
Receiver is defective. (Modem, etc.)
FCB PCB is defective.
410RCVDReceived DCN while waiting for Interface or line is faulty.
post command. (EOP, MPS, EOM, Transmitter is defective.
etc.)
411RCVBReceived DCN after transmitting Transmitter is not ready for polling
(Polling)NSC.communication.
Password does not match between the
transmitter, and the receiver.
412G3 RXB, D No response within 12 seconds in Transmitter is defective.
NSS/DCS/MPS wait state. (After FCB PCB is defective.
transmitting FTT)
414RCVBNo response received after Password does not match between the
(Polling)transmitting 3rd NSC.transmitter, and the receiver.
Transmitter is defective. (No original,
document jam, etc.)
415XMTBRemote side attempted to receive Inform the remote side that your
(Polling)message from your machine in machine does not have the polling
polling communication.transmission feature.
416RCVDReceiver did not detect post Transmitter is defective.
command, such as EOP, MPS, Line quality is poor. (RTC signal is
EOM, etc.distorted due to line noise)
FCB PCB is defective.
417RCVCReceiver returned RTN in Line quality is poor. (There are
response to post message.excessive errors in received data)
FCB PCB is defective.
418RCVCReceiver transmitted PIN in Line quality is poor. (There are
response to PRI-Q from excessive errors in received data)
transmitter. (Transmitting operator FCB PCB is defective.
requests voice contact)
420RCVBT1 timer (35 sec.) elapsed without There is wrong incoming call.
detecting 300 bps signal.(Non-facsimile communication)
Transmitter is defective.
FCB PCB is defective.
421RCVBBusy Tone is detected after Remote station disconnected the line.
sending NSF Signal.Wrong number is dialed.
308
Ver. 2.0SEPT 2006 |
ACEC
