Mechanical Instructions DVDR1000 /0x1 /6914.GB 35
4.3Service Hints
4.3.1 DVDR Module VAE8010/01
This module, item 81 in exploded view, must be exchanged
completely in case of failure. A new unit can be ordered with
codenumber 9305 025 81001.
4.3.2 Service Positions
Front
Figure 4-4
Digital Board
After demounting of DVIO board, the top side of the digital
board is in reach. To reach the bottom side of the digital
board, the DVDR module must be demounted together with
the digital board. Connected to each other, the assembly can
be set in a service position. In this position, the bottom side
of the digital board and the servo board are in reach to be
serviced.
Figure 4-1
DVIO Board
To put the DVIO board in a service position, an extender
board must be used. This extender board can be ordered
with codenumber 3104 128 07770.
Figure 4-5
Figure 4-2
Figure 4-6
Analog Board
To put the analog board in service position, demount the
assembly of analog board and backplate as follows:
1. Remove 3 screws from the backplate to the frame
2. Remove the screw from the backplate to the mains inlet
of the power supply
3. Remove the screw of the analog board to the frame
Figure 4-3 |
ACEC
