DEVELOPMENT UNIT30 March 1999
A269R310.WMF
3. Hold the development unit inside a collection bag, rotate the unit until the
opening faces downward, and shake the unit slightly to dump the developer.
4. When the agitator section gets almost empty, orient the development sleeve
face up and rotate the sleeve in the reverse direction.
5. When no more developer falls down, rotate the sleeve in the forward direction
several turns while maintaining the sleeve?s orientation.
6. Tilt the developer assembly so that its bottom faces upward to dump the
remaining developer out of the agitator section.
7. Repeat steps 3 to 6 until no more developer is collected. (A small amount of
developer will remain in the development unit?about 10 grams. This is all
right.)
6-52 |