DETAILED SECTION DESCRIPTIONSMay 29th,1995
PRINTING
Jam Detection
ConditionError Code
When theWhen the registration sensor is not turned on within
standard2.0 seconds of the paper feed clutch signal. (The
cassette is usedstandard cassette mechanism does not use the paper9-07
feed clutch, but the cpu sends it a signal anyway, and
the jam timing starts from this signal.)
When theWhen the paper feed out sensor is not turned on
standard, 100within 2.6 seconds after the paper feed motor s9-08tarts to
sheet cassette,feed paper for printing (not for prefeed).
or bypass feedWhen the registration sensor is not turned off within X
slot is usedseconds after it turned on.
9-08
X seconds = (paper length / 67.546) + 3 seconds
(67.546 mm/ s : paper feed speed)
When the bypassWhen the registration sensor is not turned on within 2
feed slot is usedseconds after the paper feed motor starts rotating for
printing.
(This error is not generated during prefeed, to allow
the users to change their minds after putting paper in9-80
this slot. When the bypass feed sensor is turned on,
the machine prefeeds the paper for up to 1 second
and stops feeding even if the registration sensor is not
turned on. If the registration sensor did not turn on at
prefeed, the machine checks for the above error.)
When the bypass feed sensor is not turned off within
11.9 seconds after it is turned on.
Using the same formula as above (error code 9-9-8108), it
works out that individual sheets cannot be longer than
about 60 cm.
When the 100When the registration sensor is not turned on within
sheet cassette is2.0 seconds of the paper feed clutch turning on.9-82
used.
2-34 |
ACEC
