SERVICE TABLES AND PROCEDURESNovember 28th, 1995
SERVICE LEVEL FUNCTIONS
4.1.17. Printing the EEPROM Information Sheet and Initializing the
EEPROM (Function 11)
Note: This procedure can be done only when a black ink cartridge is installed.
The machine calculates the amount of ink ejected to the ink absorbers and
stores it in the EEPROM on the IJC board. If the amount of ink reaches a cer-
tain threshold, the printer stops printing until the ink absorbers are replaced
and the counters in the EEPROM are reset.
To check the current amount of ink in the ink absorbers, print test pattern no.
# (EEPROM information sheet) as shown below.
FUNCTION KPAD/NEXT
1.FU 6 1 9 9 5
SERVICE FUNCTIONS
then immediatYely
0-PATTERN 1-CARRIAGE
2.1 1 Y2-SENSOR
PATTERN PRINT KPAD
3.0
0-9,#
4. Press #.
The machine prints EEPROM information sheet. The format of the sheet
is give below.
ROM Ver 1.07Dipsw1~13 1010001000100XX.X BBBBBB CCCCCC
Calculated amount of
ink received to the ink
absorbers in percentage
Paper feed counter
when using a black
cartridge
Paper feed counter
when using a colour
cartridge
H505M502.wmf
To reset the counters in the EEPROM, select test pattern no. 9 (Initializing the
EEPROM) with function 11 as shown below.
FUNCTION KPAD/NEXT
1.FU 6 1 9 9 5 SERVICE FUNCTIONS
then immediatYely
4-10 |
ACEC
