I
~
.
4-3-6 Screen Adjustment
1. Tune to the ACTIVE channel.
2. Adjust the FACTORY key is pressed on Remote Controller, Factory Mode shows up.
3. Selected OSO colar is red.
4. When the VOL + keyis pressed, the screen turns to one horizontalline.
5. Adjust SCREEN VR of FBT to make 1 dot bar.
6. After adjustment, once VOL + key is pressed again, it turns to FACTORY Mode.
4-3-7 WHITE BALANCE ADJUSTMENT (MANUAL)
1. Tune the monochrome (Lion head pattern) channel and warm up the set far 20 minutes.
2. Select the FACTORY MODE. THE FACTORY (Service) MODE is activated by pressing the
"FACTORY" button on the remote contrai.
3. On Factory mode, select number 5.
4. By using PROGRAM UP/DOWN button, select "WB ADJ".
5. Press the VOL + button to make horizontalline.
6. Adjust the VR Screen far a 1 dot line.
7. Adjust the cut-off controls to obtain the white horizontalline. The lines may look like white if the
cut-off controls are adjusted properly.
Remocon
Button NO 1 2 3 5 6 7
FtiRED- GREEN- BLUE- RED- GREEN- BLUE-
unc onD.D.D.
nve nve nve Cufo ffCutoff Cutoff
Default 35 35 35 380 380 380
Data
Example of the adjustment (If reference colar is BLUE)
1. On horizontalline (blue colar)
2. Press button no. 5 on Remote Controller.
3. By using VOL +,- button, make/set magenta colar in 1 dot line.
4. Press button no. 6 on Remote Controller.
5. By using VOL +,- button, adjust the colar to become white horizontalline.
6. To make correct white line, repeat the above no.2-5.
7. After adjustment, press factory button to return to factory mode.
8. In case of W/B adjustment in high iuminance condition, it should be done in R-H, G-H, B-H
selection
4-3-8 FOCUS Adjustment
1. Input a cross dot signal.
2. Adjust the tuning contrai far clearest picture.
3. Adjust the FOCUS contrai far well defined scanning lines in the center area of the screen.
~j12~
;."! |
ACEC
