Service Manual CE17A2-C
3.-SPECIAL MODE FOR FACTORY
The factory mode is a special TV working mode, thought to aid the manufacturing process and it is identified by the
message ?FAC?. This mode is not intended for customer use..
The Factory mode differences with respect to normal mode are the followings:
1. The TV set does not pass to standby mode after 10 min. without aerial signal input. Instead it remains
switched on.
2. The adjustments speed is four times quicker.
3. The standby mode is disabled.
To take TV set out of Factory mode, push the key of remote control.
4.-DESCRIPTION OF HOTEL MODE
By defect the TV set switches on with the program in which is was switched off, but it is also possible to force it to
switch on in a program that can be chosen between the 1 and 8 or AV.
The TV set has a special mode of operation that is adapted for use in hotels, hospitals, etc. In this case the
maximum volume level is limited to the volume chosen when the hotel mode is enabled. Furthermore, in this mode
it is not possible to do channel searching neither to modify the fine tuning control. Additionally there is the ?Hotel
Rental? mode in which it is only possible to change the program with the remote control, and it is not possible to do
so with the front keys.
These software configurations are stored in the non volatile memory and therefore they remain even though
the TV set is disconnected from the power supply. The Hotel mode configuration can be changed by pushing the
SET front key and without loosing it, pushing the key of remote control. In the case of Rental mode, the
modification procedure is the same as above but it is necessary to previously set the colour control to zero. When
all this is done, the following indication appears on the screen:
00 HOTEL
The first, most significant digit indicates weather Hotel mode is chosen or not
0 a Normal mode
1 a Hotel mode
2 a Hotel Rental mode
The last, least significant digit indicates the programme in which the set switches on
0 a The same as it was selected when the TV set was switched off.
1 a Always programme position 1.
2 a Always programme position 2.
..........
8 a Always programme position 8.
9 a Always AV mode.
The wanted code should be introduced with the numerical keys of remote control. Always to push the complete
code.
Example:
00 a Normal mode. Switches on with the same programme selected when the TV set was switched off.
10 a Hotel mode. Switches on with the same programme selected when the TV set was switched off.
11 a Hotel mode. Always switches on in programme 1
21 a Hotel Rental mode. Always switches on in programme 1.
09 a Normal mode. Always switches on in AV mode
5.-ACTIVATION OF THE INITIAL AUTOMATIC CHANNEL-SEARCH.
In order to reset the initial automatic channel-search function, enter the tuning menu by keeping pushed the frontal
SET key for a few seconds. Afterwards select the AUTO tuning mode by pushing several times the + or - key. Then
push the M key to start searching and switch-off the TV set before any station is found. When the TV set is switched
on again it will remain in the same situation as when it was switched off.
3 |
ACEC
