25WF30
SERVICE MODE 2
G-DRIVE B-DRIVE
63
DATA
INITIAL
DRIVE
DATA0 - 127DOWN4KEY 5KEY 6KEY F/B KEY 0KEY
FORWARD : CH DOWN KEY REVERSE : CH UP KEYLENGTH
3 sec. TIME OUT
Press service/ language for 2 sec, it will enter into service mode 2.Press service/ language for 2 sec again, it will jump back to service mode 1."�/��"
3-2
UP
BKGD MODE1KEY 2KEY 3KEY 7KEY 8KEY
CUT OFF
LATERAL MODE
(R, G, B-CUT OFF)
CUT OFF/ BKGD MODE
SERVICE MODE
Press the MENU button again at the remote controller, it will jump back to Service Mode 1.
50Hz ADJ. MODESUB 1 ADJ. MODE
3 sec. TIME OUTKEY
OPTIONR-CUT OFF G-CUT OFF B-CUT OFF G-DRIVE B-DRIVE
63
SERVICE MODEDATA
SERVICE MODE 1CUT OFF MODE60 Hz ADJ. MODEINITIAL
CUT OFF
R-CUT OFF G-CUT OFF B-CUT OFFDATA
LENGTH63 - 255
RASTER MODESUB 2 ADJ. MODE
1.) In the Service Mode, Key is used to select the mode in the following order.Press the MENU button at the remote controller, it will enter into Service Mode Option.
2C bus control and in the
C bus control include preset-only items
2
3-1
ADJUSTMENT PRECAUTIONS
Make a short-circuit JA373 and JA374, enter into the service mode. (Adjustment through the I2C bus control). (Use JWS Key to set as well).Press the CH DOWN / UP key on the remote controller to get ready to select the mode one by one.Press the CH DOWN / UP key on the remote controller to select the modes reversibly one by one.Using the VOLUME UP/ DOWN key on the remote controller, the data can be modified.When the short circuit between JA373 and JA374 is cut off, it will be released from the service mode.Make a short-circuit JA373 and JA374 and turn on the main power switch. Initial values are automatically preset, only when a new EEPROM is used (Judge with the first 4 bytes).The initial data are preset as listed in page.Make sure the data need modify or not (Initial data).FIRST TIME, make sure to make a short-circuit JA373 and JA374 to switch to the service mode position first and then turn on the main power switch. (See 2-1 above).Precaution: If havenOt done this initiation, it may possibly generate excessive Beam current.
12345123
This modelOs setting are adjusted in two different ways: though the Iconventional analog manner. The adjustments via the Iand variable data.1.Setting the service mode by the microprocessor.2.Factory Presetting.Note:Once the chassis has been assembly together and ready to be POWER ON for the
3 |
ACEC
