AH/AU-X108E
AY/AE-X108E
AH/AU-X138E
AY/AE-X138E
9. Remove the control box cover.
14.Remove two connectors of the fan motor and one of
Holding its bottom, pull and disengage the upper hook
louver motor.
toward the bottom.
15. Remove the indicator assembly.
(Push the upper two hook of the LED holder , and the
indicator will be ready for removal.)
10. Remove the ground wire. (One screw)
Note:During reassembly, take care for the direction
of the lead wire.
16.Remove four fastening screws of the control box, and
remove the control box.
11. Remove the protect cover for the dew.
Note:During reassembly, verify that the dew on the
pipe is recovered to the drain pan.
17.Remove the fastening screws of the drain pan. (One
screw on the left side.)
12. Remove the thermostat of the evaporator.
(Pull it out after peeling off the thermoseal.)
18.Turn the cap area of the drain hose counterclockwise,
and remove it from the drain pan.
Drain Hose
13. Cut the tie band of the lead wire.
Drain pan
Projection
Groove
During installation, turn the drain hose to the state of
the Oengagement position�.
After reinstallation, verify that it is securely fastened.
To disconnedTo reconnect
39 |
ACEC
