AR-PB2
10) Remove the securing screws holding the P side OP cover in the
Wire saddle
rear lower cover which was removed in the step 2, then remove
the P side OP cover.
Next, paste an attached label at the position only for Sweden
and Norway as shown in the illustration.
P side OP cover
Label
Securing
Printer relay cable
screws
(2) Expansion memory installation
a. Memory expansion in the printer control PWB
11) Hook the rear lower cover on the securing screw 4 which wasNormally there is no need for memory expansion. However,
loosened in the step 1 as shown in the illustration.memory expansion will increase the printer performance.
Next, tighten the securing screws 1, 2 and 3 temporarily,When printing graphics or complex data, memory expansion will
which were removed in the step 2 and tighten the securingincrease printing speed.
screw 4 which was loosened, tighten the securing screws 5,Memory of 16MB or 32MB can be installed to the two slots. (16MB
6 and 7.
onboard)
Reinstall the rear cover tighten (which was removed in the step
Different capacity of memory can be installed to the two slots.
2) to the original position by putting it onto the securing screws
The total memory after expansion may be 32, 48, 64, or 80MB.
1, 2 and 3 which temporarily secure the rear cover, then
After the above procedure, select VM Option menu and set the
tighten the securing screws 1, 1 and 3 after tightening the
total memory capacity.
securing screws 8 and 9.
b. ICU PWB memory expansion
Securing screw
The copier ICU PWB requires total memory capacity of 16 (20)MB
or more.
Memory of 16MB or 32MB can be installed to the two slots. (4MB
onboard)
Rear cover
Different capacity of memory can be installed to the two slots.
B. Stand-alone environment (Printer (parallel)
Loosened
cable connection)
screw
Rear lower Plug the connector of the Centronics cable (sold separately) into the
coverCentronics port on the printer box base.Plug the other connector into
the laser printer port on a personal computer.
Securing
screws
12) If equipped with the RADF/ADF/SPF, reinstall the connector that
was removed in the step 2 to the original position on the main
copier unit, then secure with screws attached to the connector.
Connector going to the
laser printer port on the
personal computerCentronics cable
(sold separately)
Screw
Connector
1 Connect the printer relay cable to the connector of printer
box.
2 Attach the packaged wire saddle to the printer relay cable.
3 Insert and attach the wire saddle at the position of rear lower
cover as shown in the illustration.
3 � 3 |
ACEC
