SECTION 1
SERVICING NOTE
HOW TO OPEN THE DISC TRAY WHEN POWER SWITCHCD-TEXT TEST DISC
TURNS OFF
This unit is able to display the text data (character information)
Insert a tapering driver into the aperture of the unit bottom, and turnwritten in the CD on its fluorescent indicator tube.
in the direction of arrow.
The CD-TEXT TEST DISC (TGCS-313: J-2501-126-A) is used
*To close the disc table, turn the driver in the reverse direction.for checking the display.
To check, perform the following procedure.
Procedure:
1. Turn ON the power and set the test disc.
2. Press the � button and play back the disc.
3. The following will be displayed on the fluorescent indicator tube.
Display : 1kHz/0 dB/ L&R
4. Rotate the  AMS ? knob to switch the track. The text
data of each track will be displayed.
Restrictions in CD-TEXT Contents and Display
The micro processorOs RAM has limit of capacity in this unit, The
display may not show all the track titles in a disc when you play the
CD TEXT TEST DISC, but it is not unusual. In that case, ONOT
DISPLAY� appears in the display.
Pull out disc table
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK
OR BASE UNIT
The laser diode in the optical pick-up block may suffer
electrostatic breakdown because of the potential difference
generated by the charged electrostatic load, etc. on clothing and
the human body.
During repair, pay attention to electrostatic breakdown and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused
on the disc reflective surface by the objective lens in the optical
pick-up block. Therefore, when checking the laser diode emission,
observe from more than 30 cm away from the objective lens.
LASER DIODE AND FOCUS SEARCH OPERATION
CHECK
Carry out the OS curve check� in OCD section adjustment� and
check that the S curve waveform is output two times.
N 3 N |
ACEC
