HCD-CP100/CP100K
SECTION 4
TEST MODE
[Cold Reset][CD Aging Mode]
Y The cold reset clears all data including preset data stored in theThis mode can be used for operation check of CD section.
RAM to initial conditions. Execute this mode when returning
the set to the customer.Procedure:
1. Load a CD disc.
Procedure:2. Set to standby state.
1. Turn ON the power.3. Press three buttons ofx (TAPE),x (CD), and [TUNING --]
2. Press three buttonsx (TAPE), x (CD), and [BAND]simultaneously.
simultaneously.4. The aging is executed in bellow sequence.
3. The set is reset.5. To exit from the aging modeI/1, prbutton to turn theess the
power OFF.
[Liquid Crystal Display All Lit Check Mode]
Aging mode sequence:
Procedure:
1. Set to standby state.Start
2. Press three buttons ofx (TAPE),x (CD), and
[TUNING MODE] simultaneously.
3. Liquid crystal display are all turned on.
4. To exit from this modeI/, press the1 button to turn the powerOpen the disc tray
OFF.
[Tape Deck Aging Mode]
Close the disc trayThis mode can be used for operation check of tape deck section.
Procedure:
1. Set a tape in the tape deck.
Play the last track
2. Set to standby state.
3. Press three buttons ofx (TAPE),x (CD), and [TUNING +]
simultaneously.
4. The aging is executed in bellow sequence.
5. To exit from the aging modeI/1, prbutton to turn theess the
power OFF.
Aging mode sequence:
Start
Shut off
FWD Play
1 minute
REC pause for 3 seconds
Shut off
FWD REC
3 minutes
Fast forward
REV PlayShut off
1 minute
REC pause for 3 seconds
Shut off
REV REC
3 minutes
Rewind
12 |
ACEC
