DCR-TRV25/TRV27
2-2. EVF SECTION (LB-077 BOARD)
1 Raise the EVF in the
direction of the arroA w
and slide it in the direction
of the arroB. w
BA
2 Two tapping scresw
(M1.7 � 6)
Caution
When separating the 7 LB-077 board and
Lamp guide from the 6 VF lens assembly
by removing the three 5 claws, do not face
the side of the VF lens assembly on which
the LB-077 board is installed, downwards.
Because the Illuminator and others may fall
out of the VF lens assembly, hold the
illuminator and others using tape or paper
as shown to prevent them from falling.
Be careful on this point especially when
4 VF cabinet (upper) removing the LB-077 board and Lamp
assemblyguide because the three claws located in
the VF lens assembly are easy to break.
3Two claws
6 VF lens assembly
Prism sheet5 Three claws
Illuminator
Hold the illuminator
and others using
7 LB-077 board, Lamp guidetape or paper as
shown to prevent
them from falling.
9 Lamp guide
8 Two claws
q; LB-077
board
2-4 |
ACEC
