DCR-TRV24E/TRV25E/TRV27E
SELF-DIAGNOSIS FUNCTION
COVERCOVER
1.SELF-DIAGNOSIS FUNCTION2.SELF-DIAGNOSIS DISPLAY
When problems occur while the unit is operating, the self-diagnosisWhen problems occur while the unit is operating, the counter of the
function starts working, and displays on the viewfvieinderwfinder, LCD screen, LCD screen or LCD window consists of an alphabet
or LCD window what to do. This function consists of twand 4-digo display;it numbers, which blinks at 3.2 Hz. This 5-character display
self-diagnosis display and service mode display.indicates the Orepaired by:�, Oblock� in which the problem occurred,
Details of the self-diagnosis functions are provided in the Instructionand Odetailed code� of the problem.
manual.
Viewfinder or LCD screenLCD window
C : 3 1 : 1 1
C : 3 1 : 11
Blinks at 3.2Hz
C3 1 1 1
LCD window
Repaired by:BlockDetailed Code
C : Corrected by customerIndicates the appropriateRefer to page 6.
H : Corrected by dealerstep to be taken.Self-diagnosis Code Table.
E : Corrected by serviceE.g.
engineer31 ....Road the tape.el
32 ....Turn opower again.n
3.SERVICE MODE DISPLAY
The service mode display shows up to six self-diagnosis codes shown in the past.
3-1. Display Method
While pressing the OSTOP� key, set the switch from OFF to OVCR �, and continue pressing the OSTOP� key for 5 seconds continuously. The
service mode will be displayed, and the counter will show the backup No. and the 5-character self-diagnosis codes.
Viewfinder or LCD screenLCD window
[3] C : 3 1 : 1 1
3 C : 3 1 : 11
Lights up
[3] C : 3 1 : 1 1
Control dial
Backup No.Self-diagnosis Codes
Order of previous errors
3-2. Switching of Backup No.
By rotating the control dial, past self-diagnosis codes will be shown in order. The bac which thekup No. in the [] indicates the order in
problem occurred. (If the number of problems which occurred is less than 6, only the number of problems wshown.)hich occurred will be
[1] : Occurred first time[4] : Occurred fourth time
[2] : Occurred second time [5] : Occurred fifth time
[3] : Occurred third time[6] : Occurred the last time
3-3. End of Display
Turning OFF the power supply will end the service mode display.
Note: The Oself-diagnosis displa� data will be kyept even if the lithium battery (CK-108 board BT5201 of the cabinet (R) assembly) is removed.
N 5 N |
ACEC
