DCR-TRV24E/TRV25E/TRV27E
2-9. LB-077 BOARD
4 VF flexible retainer sheet
3 Flexible retainer
Caution
metal sheet
When separating the q; LB-077 board2 Claw
and Lamp guide from the qa VF lens
assembly by removing the three 9 claws,
do not face the side of the VF lens
assembly on which the LB-077 board is
installed, downwards.
Because the Illuminator and others may1 Screw
fall out of the VF lens assembly, hold the (M1.7 � 2.5)
illuminator and others using tape or paper
as shown to prevent them from falling.
Be careful on this point especially when
removing the LB-077 board and Lamp
guide because the three claws located in 7 VF cabinet (upper)
the VF lens assembly are easy to break. assembly
Prism sheet
Illuminator6 Two claws
Hold the illuminator 8
and others using
tape or paper as
shown to prevent
them from falling.
5 Two tapping
screws
(M1.7 � 6)
qa VF lens assembly
qd Lamp guide
qs Two claws
9 Three claws
q; LB-077 board, Lamp guide
qf LB-077 board
2-9 |
ACEC
