HCD-DX20/RG30
[MC Test Mode][Microprocessor version display]
Y This mode is used to check operations of the respective sectionsY If the following operation is performed during the POWER OFF
of Amplifier, TUNER, CD and Tape.in the modes other than the POWER SAVE mode (i.e., while the
Demo display shows the watch time),
Procedure:1. When three buttons of STOP , ENTER , V (CUSOR DOWN)
1. Press the ?/1 button to turn on the set.are pressed at the same time, the MC and the GC microprocessor
2. Press the three buttons of x , ENTER and DISC 3version numbers are displayed as M1.00 G1.00.
simultaneously.2. When three buttons of STOP , ENTER , v (CUSOR UP) are
3. A message TEST MODE appears on the FL display tube.pressed at the same time, the model name and destination are
Y The messages VACS1 to VACS5 are displayed when the VACSdisplayed as BG1 AS1A3.
is changed in this mode.
Y The number of repeats of TAPE and CD is set to the infinite
number as the default setting.
4 When v (CURSOR UP) button is pressed, GEQ increases to
its maximum and a message GEQ MAX appears.
5. When V (CURSOR DOWN) button is pressed, GEQ decreases
to its minimum and a message GEQ MIN appears.
6. When b (CURSOR LEFT) or B (CURSOR RIGHT) button
is pressed, GEQ is set to flat and a message GEQ FLAT
appears.
7. In the test mode, the default-preset channel is called even when
the TUNER is selected and an attempt is made to call the preset
channel that has been stored in memory, by operating the Shuttle
knob. (It means that the memory is cleared.)
8. When a tape is inserted in the Deck B and the TAPE B function
is selected, and when the REC PAUSE/START button is
pressed twice, recording starts.
The VIDEO function is selected automatically as the input
source.
9. Select the desired loop by pressing the PLAY MODE button
in the TAPE B function. Insert a test tape AMS-110A or AMS-
RO to Deck A.
10. Press the SPECTRUM button to enter the AMS test mode.
11. After a tape is rewound first, the FF AMS is checked, and the
mechanism is shut off after detecting the AMS signal twice.
12. Then the REW AMS is checked and the mechanism is shut off
after detecting the AMS signal twice.
13. When the check is complete, a message of either OK or NG
appears.
14. When the two buttons of SPECTRUM and DISC1 are pressed
at the same time in any function modes, either the VACS ON
display to enable the VACS function or the VACS OFF display
to disable the VACS function can be selected.
15. When you want to exit this mode, press the ?/1 button twice.
The cold reset is enforced at the same time.
14 |
ACEC
