HCD-GNX60/GNX70/GX9900
[VACS ON/OFF][AGING MODE]
YThis mode is used to switch ON and OFF the VACS (VariableThis mode can be used for operation check of CD section.
Attenuation Control System).Y If an error occurs, the aging operation would stops and the
status is displayed.
Procedure:Y If there are no error occurs, the aging operation would
1. Press button to turn the set ON.continues repeatedly.
?/1
2. Press x button and [ILLUMINATION] button simultaneously.
Procedure:
The message OVACS OFF� or OVACS ON� appears on the
1. Press button to turn the set ON
fluorescent indicator tube.?/1
2. Select CD function.
[TUNER STEP CHANGE]3. Load three discs on the disc tray.
YThe step interval of AM channels can be toggled between 94. Press [PLAY MODE] button repeatedly to select the OALL
kHz and 10 kHz.DISCS� mode, and press the [REPEAT] button repeatedly to
select OREPEAT OFF� mode.
Procedure:5. Press x button, [ENTER] button, and [EX-CHANGE/DISC
1. Press button to turn the set ON.SKIP] button simultaneously.
?/1
6. Aging operation is started.
2. Press [TUNER/BAND] button repeatedly to select the OAM�.
7. To release this mode, press button or disconnect the
3. Press button to turn the set OFF.?/1
?/1
power cord to turn the power OFF.
4. Press [ENTER] button and button simultaneously. The
?/1
system will turn ON automatically. The message OAM 9k
Aging mode sequence:
STEP� or AM 10k STEP� appears on the fluorescent indicator
tube and thus the channel step is changed.
Start (from disc 1)
[CD SERVICE MODE]
YThis mode let you move the CD sled motor freely. Use this
mode when you want to clean the optical pick-up.Disc chucking
Procedure:
TOC reading
1. Press button to turn the set ON.
?/1
2. Select CD function.
Play first track for 2 seconds
3. Press x , [ENTER] button, and ZOPEN/CLOSE button
simultaneously.
4. The CD service mode is activated. The message OSERVICEPlay last track for 2 seconds
MODE� appears.
5. With the CD in stop status, turn mM knob to clockwise
EX-CHANGE open/close
rotation to move the optical pick-up to outside track, or turn
m M knob to counterclockwise rotation to move to
Open the disc tray
inside track. The message OSLED OUT� or OSLED IN�
appears on the fluorescent indicator tube.
6. To turn on or off the laser, press [DIRECTION] button. TheDisc skip
message OLASER ON� or OLASER OFF� appears on the
fluorescent indicator tube.
7. To release this mode, press button.Close the disk tray
?/1
Change the next disc
18 |
ACEC
