1-9. Character Display Function
1-9. Character Display FunctionThe contents of the pages displayed on the SD analog
monitor are as follows.
The character generation circuit built into the unit can mix
character information such as the settings, state and self-PageTitle
diagnosis of the unit with the SD video signal, output it0Display OFF (CHARACTER button OFF)
from the PIX OUT (RC-86 board output) and CHARAC-1System Status
TER OUTPUT connectors, and display it on the SD analog2Auto & Diag
monitor.3Camera Status
The character MIX function output from the PIX OUT
4SD Signal Status
connector can be forcibly turned off by turning off the5System Diag 1/3
S102-5 switch on the AT-141 board.6System Diag 2/3
When the SD analog monitor is connected to the CHAR-
ACTER OUT connector, only characters are displayed in7System Diag 3/3
black and white.8AT Diag
9DPR Diag
Operating procedure10Slot-2 Diag
To display the setting, state and self-diagnosis display of11Slot-3 Diag
the unit on the SD analog monitor, press the CHARAC-12Camera Diag
TER button of the RCP so that the button lights.
To change the page, press the CHARACTER button of the13ROM Version
RCP. The page can also be changed by pressing the S131
Required equipment
switch on the AT-141 board.. Color monitor
When the CHARACTER button of the RCP is keptSony BVM-1911/2811 or equivalent (for NTSC)
pressed, the pages are changed continuously. After all theSony BVM-2011P/3011P or equivalent (for PAL)
pages are displayed, the cycling display stops on the final
page and the CHARACTER button of the RCP goes off.. Remote control unit
To display the character information again, press theSony RCP-700 series
. HDVS camera system
CHARACTER button of the RCP.HDC-900/950
n
The first page is blank. When selecting the first page, the
display of characters is OFF.
G
H
J
S102
K
L
S131
M
987654321
AT-141 board (A side)
1-16 (E)HDCU-900 MM |
ACEC
