SERVICE MODE LIST
This unit provided with the following SERVICE MODES so you can repair, examine and adjust easily.
To enter the Service Mode, press both set key and remote control key for more than 2 seconds.
Set KeyRemocon KeyOperations
Reset the user setting items (PICTURE, VOLUME, LANGUAGE and NICAM AUTO/
VOL. (-) MIN0
OFF) to the initial state for delivery.
Initialization of the factory.
NOTE: Do not use this for the normal servicing.
VOL. (-) MIN1
If you set a factory initialization, the memories are reset such as the channel
setting, and the POWER ON total hours.
POWER ON total hours is displayed on the screen.
Refer to the "CONFIRMATION OF HOURS USED".
VOL. (-) MIN6
Can be checked of the INITIAL DATA of MEMORY IC.
Refer to the "WHEN REPLACING EEPROM (MEMORY) IC".
VOL. (-) MIN7Releasing of PROTECTION PASSWORD.
Writing of EEPROM initial data.
VOL. (-) MIN8
NOTE: Do not use this for the normal servicing.
Display of the Adjustment MENU on the screen.
VOL. (-) MIN9
Refer to the "ELECTRICAL ADJUSTMENT" (On-Screen Display Adjustment).
CONFIRMATION OF HOURS USED
POWER ON total hours can be checked on the screen. Total hours are displayed in 16 system of notation.
NOTE: If you set a factory initialization, the total hours is reset to "0".
1.Set the VOLUME to minimum.ADDRESS DATA
2.Press both VOL. DOWN button on the set and Channel
button (6) on the remote control for more than 2 seconds.
Initial setting content of MEMORY IC.
3.After the confirmation of using hours, turn off the power.INIT 01 00
CRT ON 0010POWER ON total hours.
= (16 x 16 x 16 x thousands digit value)
+ (16 x 16 x hundreds digit value)
+ (16 x tens digit value)
FIG. 1
+ (ones digit value)
C-1 |