CP-S220W
Adjustment operations (reference)
90% operation75% operation50% operation30% operation
Adjustment
pointAdjustment
BrightnessBrightnesspointBrightnessAdjustment Brightness
pointAdjustment
point
0 3 20 305075 90 1000 3 20 305075 90 1000 3 20 305075 90 1000 3 20 305075 90 100
Input signal (%)Input signal (%)Input signal (%)Input signal (%)
20% operation10% operation0% operation
Adjustment point
Adjustment pointAdjustment
point
BrightnessBrightnessBrightness
0 3 20 305075 90 1000 3 20 305075 90 1000 3 20 305075 90 100
Input signal (%)Input signal (%)Input signal (%)
4 - 6 Color uniformity adjustment
Preparations
1. Perform these adjustments after the white balance6. To temporarily turn correction off, place the cursor
adjustment described in Section 4-5.on ON in the Adjust Tone menu and press the [ ]
2. Make a color uniformity adjustment for the followingkey. To turn it on again, place the cursor on OFF in
three tones.the Adjust Tone menu and press the [ ] key.
?MIN tone (approx. 10% input signal)7. Although this adjustment can also be made using
?MID tone (approx. 50% input signal)internal signals, we will here use the [MENU
?MAX tone (approx. 75% input signal)SELECT] key on the remote controller to select the
(Note that the MIN tone need not be adjusted whenfollowing two signals.
there is no conspicuous color shading during a?Solid monochrome adjustment color (use G
black signal input.)color adjustment when a color differential meter
3. Place the cursor on the tone to be adjusted in theis used)
Adjust menu and press the [ ] key. This displays?Solid white (use for adjustment other than
the Adjust Tone menu at the bottom of the screen.above)
Select the major adjustment lattice point No. and8. Reset color shading correction before adjustment.
color, then adjust them.?When 3 tones and all colors are to be reset,
4. The major adjustment lattice point numbers (a totalplace the cursor on [C. UNIF]. in the Adjust
of 17 points) corresponds to the major adjustmentmenu, press the [RESET] key and select
lattice point positions in the diagram on the right.[DEFAULT].
The color uniformity of the entire screen can be?When only 1 tone is to be reset, place the cursor
adjusted by adjusting the white balance for each ofon the tone to be reset press the [RESET] key
the points starting in order from the low numbers.and select [DEFAULT].
5. Adjustment point No. 1 controls the brightness of?Single tone and monochrome resets cannot be
the entire screen and should not be adjusted.performed.
� 10 � |
ACEC
HITACHI
