Installation
Securing the hob into the cut out
Before fitting the hob into the cut out, the sealing gasket supplied with the
hob must be fitted to the edge of the cut out. It is essential that no gaps are
left in this seal in order to prevent spillage near the hob seeping into the
cabinet below.
1) Place the sealing gasket
+
all around the edge of
the cut out.
2) Place the hob into the
cut out and secure it by
means of the relevant
fixing clamps and
sealing
screws, as shown in the
gasket
diagram. The edge of the
hob top will cut the
exceeding gasket, which
will then be easily
removed.
Proper arrangements must be taken in
30
designing the furniture unit, in order to
avoid any contact with the bottom of the
hob which can be heated when it is
a20 min50
Removable
operated.
panel
The recommended solution is shown in
diagram.
The panel fitted under the hob should be
easily removable to allow easy access if
technical assistance is needed.
33 |
ACEC
