How to use the dishwasherUpper and lower rack
1. After loading the dishwasher, c6.losOne thece th e Start indicator lamp has The rack must be level on both Lower rack
door properly and open the water switched off press the On/Off buttsidon es.to
supply tap.switch the dishwasher o All theff. Crockery holders:A
2. Press the On/Off button to switchindic the ator lamps switch off. Down: cups and long-stemmed glasses.
dishwasher oOnn.e o f the programme 7. Open the door (warning: beware of ho Up: plates.t A
indicator lamps will switch on.steam). Unload the lower rack before
the upper one. Close the water tap.
3. Select the desired programme by
Upper rack
pressing the corresponding button.
The corresponding indicator lamp
lights up.If required, select options (if B
C
supplied).
4. Press the Start button to start the
?Vario Organizer? multi-purpose
selected programmThee. Start
support:
indicator lamp will light up Once s.et, Half Load:
To be used, for example, for long-
the programmed data cannot be Loading the lower raonlcky g ives
handled utens(ailsrra nge knives
altered by pressing the programme greater washing power, especially for
with the blade facing downwar ds),
selector buttons.plates and saucepans.
cups and glasses.
Note: once the Start button has been May be used in three differentPl ate holders:
pressed, the dishwasher memorises the positions (see ?Dishwasher also May be lowered to increase
last programme selected. This Half Load:loading instructi? onons Page 4).available spacA).e (
information remains in the memoryIf th even e upper onlyrack i s to be loaded, place 1. Upon the left-hand side of the rack.
during interruption of the power suppthe culy.tlery bas ?Bke? itn the upper rack. 2. Upside-down, towards the centre of A
To change the selected the rack.
programme, press the Start button 3. Upside-down, towards the left side.
for about 5 sec, untilonds the Start
indicator lamp switches off.
Select a new programme and press
the Start button.
Note: if the dishwasher is switched off Cutlery basket:
during a wash programme, when The cutlery basB +ket C () can
switched on again it will resume the wash be removed to increase
cycle from where it was interrupted.available space.
Only open the dishwasher door if Some models are provided
strictly necessary during a wasRackh h eight adjustment:Glass holder:with a grid (D) that can be
(The dishwasher is delivered with the
cycle and exercise maximum fitted onto the cutlery basket.
upper rack in the top position).
caution. Danger of scalding from
The rack height can also be changed B
steam.D
when loaded.
5. To indicate the end of the programme,
To lower: pull ou twt to sihede
the Start indicator lamp switches off
handles and gently lower the rack.
and the End indicator lamp (if fitted)
To raise: pull uptwo the side handles
lights up (for about 30 mi. n.)C
until the rack clicks into place.
Please read the user instructions carefully. |
ACEC
