Maintenance and cleaning
Internal cleaningExternal cleaning
Ensure that the seals around the door, the detergent and rinseClean the external surfaces of the machine and control panel
aid dispensers are cleaned regularly with a damp cloth.with a damp soft cloth. If necessary use only neutral
We recommend every 3 months to run a 65°C washdetergents. Never use abrasive products, scouring pads or
programme without dishes using detergent.solvent (acetone, trichloroethylene etc....).
Cleaning the central filter
Prolonged periods of non-operation
(After each wash)
If you are not using the machine for any period of time you
Inspect the central filters (B)are advised to:
and (C) and remove any
scraps of food with a brush,1. Unplug the appliance and then turn off the water.
under running water.2. Fill the rinse aid dispenser.
C
Filters (B) and (C) are bothD3. Leave the door ajar to prevent the formation of any
removed by lifting up theunpleasant smells. B
outer one (B) pulling the
central funnel upwards.4. Leave the inside of the machine clean.
The smaller filter (C) can be
MA02
removed by pressing the two
tongues (D).
Frost precautions
Once cleaned, refit theAvoid placing the machine in a location where the temperature
filters by pressing them
down until they click intois below 0°C. If this is unavoidable, empty the machine, close
place.the appliance door, disconnect the water inlet pipe and empty
it.
Moving the machine
MA08If you have to move the machine (moving house etc....):
Cleaning the large filter1. Unplug it.
(Every week)2. Turn the water tap off.
If necessary clean the large filter (A) on both sides under3. Remove the water inlet and discharge hoses.
running water, using a brush.4. Pull the machine out together with the hoses.
To take it out, remove theAvoid over tilting the machine during transportation.
spray arm by pressing theE
two tongues (E), turn the ring
(F) anticlockwise and then
slide the whole part out.
Refit the filter following theA
above instructions in reverse
order.F
MA03
The dishwasher must not be used without
filters.
Incorrect repositioning and fitting of the filters will
produce poor washing results.
Cleaning the filters is vital to ensure correct operation of
the machine.
10 |
ACEC
