BLANCO BRFT7X Instruction Manual

Wall cupboard fittingand lifting the two stops made of metallic wire
Using the appropriate drilling jig make the four(Fig. 10P). In the filtering version, to get access
fixing holes into the bottom of the wall cupboardto the anti-grease filter the charcoal filters must
and cut the air venting hole if the hood is a ductingbe removed too.
version one (for the filtering version this hole isWarning : There is a third metallic filter (not
not necessary). Holding the hood against thevisible) which can be accessed through the
bottom of the cupboard fix it to it by means of theopening R (Fig. 12).
supplied four screws (Fig. 8).Clean the anti-grease filters depending on use
Fig. 9: take 2 of the screws (S) enclosed (the(on average every 6 months). Handwash them
smallest ones) and partially insert them in thewith neutral detergent or in the dishwasher.
holes on the telescopic slide (A); do not fix
them completely: they must hold the telescopicTo gain access to the light bulb(s), remove
slide. Push the slide back as much as possiblethe anti-grease grille as described above and
and block it with some adhesive tape (W).remove the bulb(s). Replace with lamps of the
Rest the lower part of the hood against thesame type.
wall and mark the position of the 2 holes C
(Fig. 9) on the wall with a marking pen. Remove
the lower part and drill 2 holes in the marked
positions and insert the screw anchors.
Fix the lower part by means of the 6 screws
supplied (Fig. 9).
Remove the adhesive tape from the telescopic
part and pull it downwards until it touches the
hob.
Make the electrical connections.
IMPORTANT:
Check the position of screw M (Fig. 10).
For the ducting version screw M must be
completely screwed; for the filtering version
the screw must be completely unscrewed
to let the sucked air to get out through
the top fissures.
OPERATION
--------------------------------------------------------
Controls (Fig. 11):
A = light switch.
B = first speed motor ON/OFF switch.
C =second speed switch.
D =third speed switch.
E = warning light: indicates motor operation.
In case the hood is a filtering version one, it is
necessary to change the charcoal filters (Fig.
10N) according to utilization about every six
month. To remove the charcoal filters:
- take off the anti-grease grilles as described
above.
- lift the two metallic stops (Fig. 10P).
- remove the charcoal filter.
The 2 anti-grease filters are easily removed
from the grille by opening it as described above