one needs to be tighten more. Be
careful not to tight the hex bolts to
much, the pulley threaded hex bolt
holes could be damaged
SPEED VARIATIONS The turntable speed vary ? [The AC synchronous motors ? Any speed variation with a
up and down continuously speeds can be affected only by the fixed pulley dimension is caused by your
HERTZ or eventually by the dimension AC power national supplier or by your
of the pulleys home AC system, check it out
Troubleshooting 8
Bellavista Italian Prestige Rigid Turntable
SYNPTOM DESCRIPTION CAUSE REMEDY
SPINDLE (of the Platter): The Platter wobbles on its ? Clamp the Spindle tip into the ?
CLAMPING THE edges or it vertically above side of the platter screwing it
PLATTER SPLIT SPINDLE shakes during playing strongly using a metal pin to get into the
TO THE PLATTER tip hole
? If the strongly clamp screwing ? It needs to be substituted by
of the spindle tip does not fix the platter your local dealer
enough, the platter hole is been enforced
after final user assembling
SPINDLE (of the Platter): The Spindle does not fit ? ? Unscrewing the tip, split the 2
INSERTING THE into the Platter Central pieces Spindle and fit the bottom part
PLATTER SPLIT SPINDLE Hole of the spindle into the platter through
the gold plated weigh ts side, clamp the
Spindle tip into the above side of the
platter screwing it strongly using a
metal pin to get into the tip hole
SPINDLE/BEARING (of the The Spindle makes noise ? The Platter Bearing/Spindle ?
Platter) NOISE during platter spinning system are very dirty making a too strong
friction
? The Platter Bearing/Spindle ? After a couple of weeks of
system are new and they need a break in playing clean and re-wet them with
time to sweep out all the internal some fresh oil supplied
unwanted particles
SPINDLE (of the Platter): The Records hardly fit into ? Bluenote Platter Spindle Tips ? Sorry you need to enfo rce the
TIP OF THE DIAMETER the Platter Spindle Tip have a 7,2mm of diameter that is the record into the Platter Spindle Tip
recognised international standard but
many records are wrongly moulded
SWITCHING ON/OFF The turntable bumps any ? It is important to notice that it ? Ask your local dealer to add a
BUMP time is switched ON or does not produce any risk even if the proper ceramic capacitor able to filter
OFF bump is high, but if you have a turntable such noise
with a serial number bef ore 11650
SPEAKER HUMMING The speakers hum when ? The Turntable CAN NOT ? Eventually a tone arm cable
PROBLEMS the turntable is connected makes any noise hearable into the problem can occur; please check other
to the system speaker by itself ways out
TURNTABLE (THE) DOES ? The AC turntable plug is ? Connect it being sure that the
NOT START WHEN THE disconnected from the AC wall plug AC wall plug works
TURNTABLE IS
SWITCHED ON
The Turntable just does ? Have you wrapped the Belt ? If not just do it
not start around the Pulley and the Platter
properly |
ACEC
