IMPORTANT NOTES
357
Y Do not put anything that contains water (e.g., flower Maintenance
vases) on the unit. Also, avoid the use of insecticides, 401a
perfumes, alcohol, nail polish, spray cans, etc., near the Y For everyday cleaning wipe the unit with a soft, dry cloth
unit. Swiftly wipe away any liquid that spills on the unit or one that has been slightly dampened with water. To
using a dry, soft cloth.remove stubborn dirt, use a cloth impregnated with a
359Y Do not paste stickers, decals, or the like to this mild, non-abrasive detergent. Afterwards, be sure to
wipe the unit thoroughly with a soft, dry cloth.
instrument. Peeling such matter off the instrument may 402
damage the exterior finish.Y Never use benzine, thinners, alcohol or solvents of any
Y During Operation, this device must be placed at a kind, to avoid the possibility of discoloration and/or
distance of no less than 50 cm from any walls.deformation.
Y Do not allow objects to remain on top of the unit while it
is in operation.Additional Precautions
553
Y If you cover the heat sink, their function is defeated, Y Use a reasonable amount of care when using the unitOs
and their temperature can rise to overly high levels, buttons, sliders, or other controls; and when using its
which could cause burns if they are accidentally jacks and connectors. Rough handling can lead to
touched.malfunctions.
Y Placing heavy objects on this unit may result in injury 556
if it overturns or falls.Y When connecting / disconnecting all cables, grasp the
connector itselfNnever pull on the cable. This way you
Y During setup and transport, be careful not to damage the will avoid causing shorts, or damage to the cableOs
vibrating portions (the speaker cone and diaphragm).internal elements.
Y Be sure to place the monitor so that the heat sink on the 557
Y A small amount of heat will radiate from the unit during
rear panel is not obstructed. Also, make sure the monitor normal operation.
does not touch any curtains or other fabrics.558b
Y The heat sink performs cooling when the monitor is Y To avoid disturbing your neighbors, try to keep the unitOs
volume at reasonable levels (especially when it is late at
placed as shown below. Do not place the monitor on its night).
side or upside down.559a
fig.06.eY When you need to transport the unit, package it in the
Heated Airbox (including padding) that it came in, if possible.
Otherwise, you will need to use equivalent packaging
materials.
562
Y Use a cable from Roland to make the connection. If using
some other make of connection cable, please note the
following precautions.
Y Some connection cables contain resistors. Do not use
cables that incorporate resistors for connecting to this
unit. The use of such cables can cause the sound level
to be extremely low, or impossible to hear. For infor-
mation on cable specifications, contact the manufac-
turer of the cable.
Y When this device is in operation, the heat sink located on
the rear panel will become hot. Take care not to touch
them with your hands.
5 |
ACEC
