Chapter 4 Introduction to Effects and Parameters
Xover f (Crossover Frequency)Hi Level (High Level)
This parameter sets the frequency at which the frequency Adjust the volume of the high frequency range.
components of the direct sound are divided into bass and
treble bands.
PAN
Lo Rate (Low Rate)
Adjust the speed of the chorus effect for the low frequency With the volume level of the left and right sides alternately
changing, when playing sound in stereo, you can get an
range.effect that makes the guitar sound appear to fly back and
* When set to BPM, the value of each parameter will be set forth between the speakers.
according to the value of the Master BPM (p. 54) specified for
each patch. This makes it easier to achieve effect sound settings ParameterValue
that match the tempo of the song (synchronizing the cycle to Wave Shape0�100
one-half or one-fourth of the BPM when the set cycle rate is
increased). Rate0�100, BPM�BPM
Depth0�100
When setting to BPM, press PARAMETER [] to display
the Master BPM settings screen.
Wave Shape
Lo Depth (Low Depth)This adjusts changes in volume level.
Adjust the depth of the chorus effect for the low frequency
range. If you wish to use this as a doubling effect, use a Rate
setting of O0.�Adjusts the frequency (speed) of the change.
* When set to BPM, the value of each parameter will be set
Lo PreDly (Low Pre Delay)
according to the value of the Master BPM (p. 54) specified for
Adjust the time from when the low frequency range direct each patch. This makes it easier to achieve effect sound settings
sound is output until the effect sound is output. Extending that match the tempo of the song (synchronizing the cycle to
the pre-delay will produce the sensation of multiple sounds one-half or one-fourth of the BPM when the set cycle rate is
(doubling effect).increased).
When setting to BPM, press PARAMETER [] to display
Lo Level (Low Level)the Master BPM settings screen.
Adjust the volume of the low frequency range.
Depth
Hi Rate (High Rate)Adjusts the depth of the effect.
Adjust the speed of the chorus effect for the high frequency
range.
VB (Vibrato)
* When set to BPM, the value of each parameter will be set
according to the value of the Master BPM (p. 54) specified for This effect creates vibrato by slightly modulating the pitch.
each patch. This makes it easier to achieve effect sound settings
that match the tempo of the song (synchronizing the cycle to ParameterValue
one-half or one-fourth of the BPM when the set cycle rate is Rate0�100, BPM�BPM
increased).
When setting to BPM, press PARAMETER [] to display Depth0�100
TriggerOff, On
the Master BPM settings screen.Rise Time0�100
Hi Depth (High Depth)
Rate
Adjust the depth of the chorus effect for the high frequency
range. If you wish to use this as a doubling effect, use a This adjusts the rate of the vibrato.
setting of O0.�* When set to BPM, the value of each parameter will be set
according to the value of the Master BPM (p. 54) specified for
Hi PreDly (High Pre Delay)each patch. This makes it easier to achieve effect sound settings
Adjust the time from when the high frequency range direct that match the tempo of the song (synchronizing the cycle to
sound is output until the effect sound is output. Extending one-half or one-fourth of the BPM when the set cycle rate is
the pre-delay will produce the sensation of multiple sounds increased).
When setting to BPM, press PARAMETER [] to display
(doubling effect).
the Master BPM settings screen.
46 |
ACEC
