Chapter 10 Other Features
Adjusting the Tone of the Sounds Input to Keeping Effect Sounds Playing After Patches
the GT-PRO (Input Level/Input Presence)Are Switched (Patch Change Mode)
The GT-PRO includes a function used for adjusting the tone The GT-PRO features a mode that is enabled when spatial
to match the connected guitar.effects (such as reverb and delay) are used, whereby the
This is effective when you are connecting a different guitar effects sound of one patch continues playing even after you
from the one used when the patch was created.switch to the next patch. If the necessary conditions
regarding the effects chain and effect parameter settings are
met, you can then have the decay of reverb, delay, and
When adjusting the input level and input presence, the
similar effects continue on into the next patch after you
input signals for all patches are affected. Note that the
switch patches.
nuances of the effect sounds that occur in response to
Y Effects are in the same effects chain
guitar volume may change, particularly with patches in
Y When switching the delay off or on, or when the type
which effects are controlled by the guitar volume.
fig.10-0260and time are identical
Y When switching other effects off or on, or when the
211
parameter settings are identical
* There still may be no reverberation in some cases, even after
the above settings are made.
fig.10-0280
211
4
1. Press [SYSTEM], then press PARAMETER []
[] to display the following screen.
fig.10-0270d
3
1. Press [SYSTEM], then press PARAMETER []
[] so that OP.Chnge Mode� is displayed.
fig.10-0290d
2. Rotate the PATCH/VALUE dial to change the settingOs
value.
2. Rotate the PATCH/VALUE dial to change the settingOs
3. Repeat Steps 1 and 2 as needed.
value.
4. Press [EXIT] to return to the Play screen.
ValueExplanation
Fast
Parameter/
ExplanationPatches are changed normally. The unit switches to the subse-
Range
quent patch without any carry-over of the decay from the pre-
Input Levelvious patchOs reverb or chorus.
-20 dB�+20 dBAdjusts the guitar input level.Smooth
Chapter 10
The unit switches to the subsequent patch with the decay from
Input Pres. (Input Presence)
the previous patchOs reverb or delay continued after the switch
Adjusts the tonal quality of the guitarOs high
-20 dB�+20 dBis made.
end.
* For smooth switching, patches may be switched with one tempo
delayed.
3. Press [EXIT] to return to the Play screen.
97 |