This appliance complies with the
following E.E.C. Directives:
Fig. 2
-73/23 EECof 19.2.73 (Low Voltage
Directive) and subsequent mod)fications;
- 89/336 EECof 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
moddfications.
Cleaning the interior
Before using the appliance for the first time,A
wash the interior and all internal accessories
with lukewarm water and some neutral soap so45°
as to remove the typical smell of a brand-newD039
product, then dry thoroughly. Do not use
Fig. 3detergents or abrasive powders, as these will
damage the finish.
Rear spacers
In the bag with the documentation, there are
two spacers which must be fitted into the
special openings provided on the back of
the appliance.
Push-fit the spacers into the openings, making
sure that arrow (A) is positioned as per Fig. 2
and then turn the spacers through 45! until they
lock in (arrow in vertical position).
Door reversibility
Unplug the appliance before carrying out
any operation.
Remove the ventilation grid (2); to do this, loose
the frontal screws and pull it downward sliding it
from the central stop runners;
remove the lower hinge (1);
remove the pin (C) from the opening (A) and
refit it in the opening (B);
remove the door stop hinge (D) and refit it on
the opposite side;
slide the lower door out of the centre hinge;
remove the centre hinge (4) and the upper
hinge (3) and refit them on the opposite side;
refit the lower door and hinge (1) on the
opposite side;
refit the ventilation grid upside-down;
take off the handle covers (Fig. 4), remove
handles and refit them on the opposite side.
Electrical connection
Before plugging in, ensure that the voltage and frequency shown on the serial number plate
correspond to your domestic power supply. Voltage can vary by ?6% of the rated voltage. For
operation with different voltages, a suitably sized auto-transformer must be used.
TECHNICAL SPECIFICATIONSGB
The technical data is indicated in the rating plate on the left side inside the appliance.
4 |
ACEC
